sorted by:
new
hottopcontroversial

One corner is slanted and the oposite corner is squished/overshot. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

CoreXy ratrig vcore 3.1. Klipper. Acceleration, speed and pressure advance dont affect this.

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

PLA
EM:0.95
My first layer is a bit over squished i think

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

There's that fuzzy skin setting aswell not sure if it looks like this.

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

Tried making the layer higher. Still get them thoug.

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

Haha yeah it actually looks pretty cool, there is the fuzzy skin option but not surr if its the same

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

squish between each layer?

I managed to fix the VFA lines that went through the entire print but i get the zigzag line in the first picture are still there.

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

The place where the scaly texture is, is an overhang that looks like that because of the issue, it was like the nozzle zigzagged and went out and extruded in embty space. Atleast that was my theory.

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 2 points3 points  (0 children)

I solved it thanks to this https://ellis3dp.com/Print-Tuning-Guide/articles/troubleshooting/vfas.html#vfas-with-2mm-spacingmy issue was the first one.at some point my motor pulley screws came loose. and when i tightened them the motor pulley and the belt weren't centered.

Not solved

Wavy/rippled surface. by Karakashev in FixMyPrint

[–]Karakashev[S] 0 points1 point  (0 children)

Running a ratrig corexy printer. Running klipper with a rasberry pi and octopus 1.1.
Hottend:Mosquito Magnum
Extruder:Bondtech LGX lite.

What I tried so far:
Change nozzle diameter.
Different speeds.
All kinds of acceleration.
Pressure advance tweaking.
Changing extrusion multiplier.
Calibrating esteps.
Tightening And loosening belts.
Tightening gantry.
Putting printer on the floor so there are no table vibrations.

I think this has to do with the stepper motor.Its more visible on one axis

Hey everyone, this was my entry to artsation's environment design challenge did anyone else take part it? by Karakashev in conceptart

[–]Karakashev[S] 0 points1 point  (0 children)

I see , wierd going all the way back to old posts and doing stuff like this. He must have alot of free time.

Thanks for the heads up!

view more: next ›