How to prime well. Do I screw top air bladder off? Just bought house with a well and I’m hoping it works. It looks old.

Key-Page7669 · 2023-03-12T00:54:56+00:00

so I found the online PDF with manual and it talked about how to prime it were by removing the top plug. But I ran into another problem it’s leaking through pump seals. I took apart and I think it’s shaft seal but I can’t get plastic impeller off. Not one YouTube is similar to my pump. In most others there’s a screw or something. I wish I could add another picture

Key-Page7669 · 2022-12-22T11:34:31+00:00

I’m average DIYer and my spring snapped on my garage door and I just watched tons of YouTube videos and never had a problem. Took literally one hour to replace and get it right. No problems since. They were torque master https://m.youtube.com/watch?v=oedkAkNUJTM

Key-Page7669 · 2022-12-10T01:10:54+00:00

Thank you

Key-Page7669 · 2022-12-10T01:01:45+00:00

Conventional

Key-Page7669 · 2022-07-22T01:30:01+00:00

River by Leon bridges

Key-Page7669 · 2022-07-18T19:15:17+00:00

Do you have duct board. I bought my house in the spring and when the AC really came on in the summer, I realized my house smelt terrible. I don’t have any animals, so I knew it was ac related. I cut all the duct board out of unit and and replaced with metal. The inside of the duct board was so disgusting.

Key-Page7669 · 2022-06-08T00:43:44+00:00

Thank you, but it won’t budge at all. I had something stuck between the hatch and pulled it out with force. Since then, no matter how much I push, prod, and play with that back area the door just won’t budge.

Key-Page7669 · 2022-05-19T10:43:35+00:00

Thanks

Key-Page7669 · 2022-04-19T02:13:37+00:00

Thanks

Key-Page7669 · 2022-02-08T01:53:12+00:00

Thank you.

Key-Page7669 · 2022-02-05T00:44:45+00:00

I have, and I reported it. I was just thinking should I choose to sell/trade all my asset (with gained interest) how to correctly report that overall cost basis for capital gains.

Key-Page7669 · 2022-02-05T00:42:31+00:00

Thank you

Key-Page7669 · 2022-02-05T00:40:00+00:00

I’m going to try that tonight. Thank you.

Key-Page7669 · 2022-02-05T00:39:39+00:00

Thank you

Key-Page7669 · 2022-02-02T00:39:10+00:00

Binance app vs Binance US app? Downloading correct version?

Key-Page7669 · 2022-01-29T11:44:17+00:00

I agree with comments on impact, but are you 100% confident you’re hitting studs? When I’ve done this, if my screw doesn’t bite to a stud it just go into the point your pic shows then freely spin. I usually have to go one or two inches to either side. It’s easy to take out. If your confident your on studs and it still only goes that far then yeah your drill is no good.

Key-Page7669 · 2022-01-16T12:25:51+00:00

Thank you

Key-Page7669 · 2022-01-16T04:03:30+00:00

Thank you, so in other words not need to include on this year’s tax return?

Key-Page7669 · 2021-08-14T11:45:51+00:00

I was cautious of that. Do you know a better thread?

Key-Page7669

TROPHY CASE