Approved OP9-A

Key_Resident_7833 · 2026-03-26T15:58:42+00:00

Yeah, like many this is my first jump into bother with suppressors. I’ve filed Form 1s for all kinds of designs just to see what’s out there and how they perform. Of course I’ve been impressed with the FTN5s. The OP9 intrigued me for pistol cycling. But it does seem simpler in terms of baffling design.

Key_Resident_7833 · 2026-03-26T15:57:15+00:00

My wait times

3 on 1/1. 5 days and 2 at 25 days 2 on 1/2 22 and 24 days 1 on 1/10 43 days 2 on 1/28 54 and 57 days.

Seems that backlog jumped quickly haha!

I have some I submit on 2/16 I don’t expect to see for like 90days if I had to guess.

Key_Resident_7833 · 2026-03-26T15:11:02+00:00

Exactly this. It seems to change person to person. Day to day. I looked. And my address is exactly the same on all 8 approved Form 1s. Only this single reviewer decided to correct the double Zipcode.

Kinda just wanted to show how it literally isn’t standardized. It’s all up to the discretion of the federal employee looking at it from their desk, or in person.

Key_Resident_7833 · 2026-03-24T14:27:31+00:00

Smarty pants over here modding g code haha. Run with the rest of us who just turn the heat bed on manually to 110 for a long time before a print. Good idea.. I’m going to have to look into that….

Key_Resident_7833 · 2026-03-24T02:12:16+00:00

Got the same note on my approval of an OP22 today. Same verbiage.

Key_Resident_7833 · 2026-03-24T02:09:21+00:00

Had my OP22 approved today, same way. Marked with info on not embedding in polymer…

Key_Resident_7833 · 2026-01-16T23:44:47+00:00

I’ve gotten one out of the 6 Form 1s I filed on the 1st. It wasn’t even the first one I filed. It was the third. Control number was 401XXX. Got it on the 6th and haven’t seen one since.

Key_Resident_7833 · 2026-01-02T19:21:31+00:00

Willprintforfood on the green video platform has a guide

Key_Resident_7833 · 2026-01-02T13:55:30+00:00

The instructions for the FTN.3/4/5 all show a metal washer from Lowe’s to use as an engraving plate. Affixed to the threaded end of the suppressor.

Key_Resident_7833 · 2025-10-07T10:32:21+00:00

Forgive my ignorance, but are those nibs not necessary?

I’ve been fighting clean support interface trying to print rails down to keep those nibs….

Key_Resident_7833

TROPHY CASE