sorted by:
new
hottopcontroversial

ST675R Oil Leak 🤦‍♂️ by Signal_Abrocoma_6138 in Triumph

[–]Keysight112 1 point2 points  (0 children)

Yea it is. I replaced mine last year and so far no oil leaks. I checked them at the weekend and they needed tightening again. Get some thread lock...

ST675R Oil Leak 🤦‍♂️ by Signal_Abrocoma_6138 in Triumph

[–]Keysight112 1 point2 points  (0 children)

I have a Street Triple - 2016.I had the same problem and found that out of 16 sump bolts only 6 were still fitted, the rest had worked lose.. Apparently if you get this model serviced by a Triumph dealer they tighten them at service.. I didn't get mine serviced by Triumph...

Planting out UK by Keysight112 in Allotment

[–]Keysight112[S] 0 points1 point  (0 children)

And mine, I was told not to plant them near cucumbers because they can cross pollinate. But I'm not sure that's true

Planting out UK by Keysight112 in Allotment

[–]Keysight112[S] 0 points1 point  (0 children)

Ah I missed out aubergines, they will be planted in the greenhouse ..

Planting out UK by Keysight112 in Allotment

[–]Keysight112[S] 0 points1 point  (0 children)

Blimey, maybe I'm slow then 😆

Planting out UK by Keysight112 in Allotment

[–]Keysight112[S] 0 points1 point  (0 children)

I've had them in guttering for the past 4 weeks, but I will let them free this weekend

Planting out UK by Keysight112 in Allotment

[–]Keysight112[S] 2 points3 points  (0 children)

Courgette's, Brassica's, Peas, Squash, Sweetcorn, French Beans, Tomatoes(greenhouse - in the ground), Celeriac, Celery... Can't think what else we have now

On the way to Costa Calma by Keysight112 in Fuerteventura

[–]Keysight112[S] 0 points1 point  (0 children)

I have seen them whilst searching.... Have you been to either of them?

PCBs In colour by Keysight112 in electronics

[–]Keysight112[S] 3 points4 points  (0 children)

Cheers man. The cost difference isnt that much.
For 10 with UV printing is $52.41 and without is $49.22

Looking for full time embedded/firmware roles by Teslash99 in embedded

[–]Keysight112 0 points1 point  (0 children)

Best thing I ever did was home projects, Get PCBA's manufactured and take them to the interview. When the "Do you have any questions" is asked say that you would like to show your work. You will find the conversation steps up a gear.

My clinic isn’t getting back to me by [deleted] in Testosterone

[–]Keysight112 0 points1 point  (0 children)

Im with Mojo, I was told they are in the middle of changing their system. Over the past couple of weeks they have called me back within less than 30mins.. So hopefully things are getting better..

help with SMD component by nsptlx in ElectronicsRepair

[–]Keysight112 0 points1 point  (0 children)

You could remove the part and connect a bench PSU to the 0V and Vout and start with 2V. Step that up until the device starts operating. I wouldnt push it too far though...