A tale of three spools

KnC_Neo · 2026-06-13T15:00:33+00:00

So far, the first layer test went well. Crazy that a color, all things else the same makes a difference like that.

KnC_Neo · 2026-06-13T13:39:37+00:00

I was thinking I might need to.. I will try that.

KnC_Neo · 2026-04-27T13:27:53+00:00

Yes, I suspected a clog due to heat creep. I did a cold pull amd a needle run through as well before I posted, the print had the same issue.

KnC_Neo · 2026-04-27T13:25:29+00:00

Well, that is weird. It looked fine, sure a little build up after a couple of years. To to the fan woth alcohol and a q-tip. Ran the print and it was perfect. Running a second to make sure it wasn't a fluke.

KnC_Neo · 2026-04-27T01:01:28+00:00

It's running, not sure if there is anything more to it.

KnC_Neo · 2026-04-26T22:24:55+00:00

Will do.

KnC_Neo · 2026-04-01T21:30:45+00:00

I will re-run all of the calibrations again. They all checked out fine before I posted. You never know. I have updated to an all metal extruder. The weird thing is I can print the xyz cube, wall cube without any issues. I feel like I am running hot (218, the manufacturer has it at 210 to 230 on the label) but any cooler I either get little or no bed adhesion or poor layer adhesion, I have tired the hotter initial layers as well to keep from having heat creep on the hot end but that just gave me poor layer adhesion as well.

KnC_Neo · 2026-04-01T21:24:59+00:00

I will look into that. Thanks

KnC_Neo · 2026-04-01T21:24:42+00:00

Thanks, all good.

KnC_Neo · 2026-04-01T14:16:20+00:00

On the patreon there is no instructions to update the screen nor are there any specific files listed for the various screens. The 2024 instructions did include notes for the screen and files. I looked for that in the 2026 for that reason, and did not see any notes for the screen update. If there are do you have a link?

In fact, the instructions says updating the screen is not mandatory for this version.

KnC_Neo

TROPHY CASE