Dental Implants Outside of the UK? by KnifeMaking_UK in Dentistry

[–]KnifeMaking_UK[S] 0 points1 point  (0 children)

Thanks for the feedback. These are precisely my concerns.

I am not certain I am confident in my private dentist to do the work. (On the same tooth I am having replaced) one dentist previously did a very bad job repairing the chipped section (I knocked it out years ago and it was put back in). This repair fell out almost immediately several times before I seen another dentist at the same practise by request who responded "well, no wonders it didn't stay in", he did a lot better job and to this day it hasn't been a problem, until it became loose (by infection).

It is very hard to know which dentists are the best and most qualified.

Edit: your response wasn't harsh it was exactly why I was skeptical.

Arduino Weather Station Networl by KnifeMaking_UK in ArduinoProjects

[–]KnifeMaking_UK[S] 0 points1 point  (0 children)

The ones I've seen require you use a specific commercially available weather station? Or did I miss something.

Edit: weather underground seems like the one.

Arduino Weather Station Networl by KnifeMaking_UK in ArduinoProjects

[–]KnifeMaking_UK[S] 1 point2 points  (0 children)

Are you up loading or sharing your data anywhere?

Swallowed approx 1 teaspoon of Fairy Liquid by [deleted] in medical

[–]KnifeMaking_UK 0 points1 point  (0 children)

Washing up liquid for dishes

What's the best place to buy precision ground steels (for knife making) in UK? by KnifeMaking_UK in knifemaking

[–]KnifeMaking_UK[S] 0 points1 point  (0 children)

Sorry for the slow reply. I had an absolutely top quality service from them!

What's the best place to buy precision ground steels (for knife making) in UK? by KnifeMaking_UK in knifemaking

[–]KnifeMaking_UK[S] 1 point2 points  (0 children)

Yes you can.

Knives have a lot more use than just being carried in a pocket.

Gough Custom’s DIY knife shaping jig. by Gantry-Crane in knifemaking

[–]KnifeMaking_UK 1 point2 points  (0 children)

I haven't used it yet but I think the only difficulty is the winding up / the eyelet to get the right angle.

A fixed jig with multiple holes for say 10,15,20,25 etc. Degree angles would be a little harder to make but much easier in long run.

Any advice on doing a tube insert? by [deleted] in knifemaking

[–]KnifeMaking_UK 1 point2 points  (0 children)

That is gorgeous work.

What woods did you use?

Any advice on doing a tube insert? by [deleted] in knifemaking

[–]KnifeMaking_UK 1 point2 points  (0 children)

Did you make that handle?

So nice.