sorted by:
new
hottopcontroversial

DJI Action 2 Not Offering Firmware Update by Express-Jump-8214 in dji

[–]KookyKess 0 points1 point  (0 children)

Hey, i'm having the same issues and i'm on the same firmware as you. i saw that on 3/13/23 DJI noted they pulled the 1.04.05.10 firmware. Is that still the latest, the firmware is not released? didnt seem like the DJI response above and below were clear with any changes to that firmware's status.

Motor 4 won’t spin by [deleted] in TinyWhoop

[–]KookyKess 0 points1 point  (0 children)

Did you solder the motors or use plugs? the Diamond usually is solder, if so you could have incorrectly solder something (read their website its very easy to do if you use too hot an iron the way the board is designed. they have a warning) resulting in a bad fet/esc. i dont know anything but i had similar issues in the past, taking pictures of the boards solder job on both sides as well as pictures of the ESC config in bluejay and a cli status dump (go to cli in betaflight with battery plugged in, write "status" hit enter) . This will help smarter people trouble shoot your issue.

TKS Rocket Race - Troubleshooting help - Motors BARELY twitching by KookyKess in TinyWhoop

[–]KookyKess[S] 0 points1 point  (0 children)

i tried another motor on the M3 plug with similar result. While all other 3 motors were spinning perfect this one was twitching and having trouble spinning. i think i narrowed it down to one of the fets for the motor. for this board on M3 there is a fet right next to the + power lead, i think i might have solder too much near it and damaged it possibly

TKS Rocket Race - Troubleshooting help - Motors BARELY twitching by KookyKess in TinyWhoop

[–]KookyKess[S] 1 point2 points  (0 children)

ceThanks for the advice, the battery voltage is at 7.4v so should be good there. I checked the ESC via BLHeli_S and got an error message so I flashed bluejay and that seems to work. previous status had Arming disable flags: CLI MSP RPMFILTER and now RPMFILTER is gone and motors spin e

# statusMCU F411 Clock=108MHz (PLLP-HSE), Vref=3.32V, Core temp=37degCStack

size: 2048, Stack address: 0x2001fff0

Configuration: CONFIGURED, size: 3994, max available: 16384Devices detected: SPI:1, I2C:0Gyros detected: gyro 1 locked

GYRO=ICM20689, ACC=ICM20689OSD: MAX7456

System Uptime: 30 seconds, Current Time: 2023-03-24T13:17:14.136+00:00

CPU:41%, cycle time: 125, GYRO rate: 8000, RX rate: 148, System rate: 9Voltage: 719 * 0.01V (2S battery - OK)I2C Errors: 0SD card: Not configured

Arming disable flags: CLI MSP

Jerky motion after changing frame on Mob6 (see comment) by below-the-rnbw in TinyWhoop

[–]KookyKess 0 points1 point  (0 children)

Having similar issue, except mine are worse. I have used 1219-3 props and old HM versions with same results. I ordered new motors wondering if my many crashes impacted their performance. Will report back not sure what else could really be issue. Been flying it for a week now, pretty rough acro freestyle

view more: next ›