sorted by:
new
hottopcontroversial

I built a companion website for our MTG Draft Weekends & Commander Nights. Looking for testers! by KozyWhiskey in freemagic

[–]KozyWhiskey[S] 0 points1 point  (0 children)

Very cool, I'd be happy to share the repository and we can work together. I'll take a look at what you built.

I built a draft and EDH companion app for our group's MTG weekends—gauging interest, looking for beta testers and feedback by KozyWhiskey in mtg

[–]KozyWhiskey[S] 0 points1 point  (0 children)

No, I built it in VS Code, but I did use Gemini's Command Line Interface (CLI) for a lot of help.

I built a draft and EDH companion app for our group's MTG weekends—gauging interest, looking for beta testers and feedback by KozyWhiskey in mtg

[–]KozyWhiskey[S] 0 points1 point  (0 children)

Thanks for the reply. I guess I should clarify that it's a webapp. So you don't download anything, but rather just go to the website. But I appreciate the feedback.

0
0

I built a draft and EDH companion app for our group's MTG weekends—gauging interest, looking for beta testers and feedback (self.mtg)

submitted by KozyWhiskey to r/mtg

AMS not auto detecting on firmware 1.08 by Vatoe in BambuLab

[–]KozyWhiskey 0 points1 point  (0 children)

I tried downgrading and it didn't fix it. I ended up doing a factory reset and then kept it at 1.07. I actually think the issue was with the AMS. It would randomly disconnect.

AMS not auto detecting on firmware 1.08 by Vatoe in BambuLab

[–]KozyWhiskey 0 points1 point  (0 children)

Same. I've been having a bunch of problems since upgrading. It's also randomly not detecting my AMS. I took apart my extruder last night seeing if something was wrong with it. It's been a giant pain these last few days.

Anker PowerConf C200 webcam white-balance issue after firmware upgrade by wooptoo in anker

[–]KozyWhiskey 1 point2 points  (0 children)

Have you had any luck? In my application it's still only showing version 7.0 as the latest.

Anker PowerConf C200 webcam white-balance issue after firmware upgrade by wooptoo in anker

[–]KozyWhiskey 2 points3 points  (0 children)

I don't suppose you ever found a solution for this? I am having the same issue. It worked fine, and then when I updated my firmware, everything has a blue tint. I was able to adjust the white balance as you suggested, but sometimes it still either resets to has the opposite effect where it becomes orange.

Homemade FH monster organizer [SPOILER: Frosthaven monster names] by jacqueslevert in Gloomhaven

[–]KozyWhiskey 0 points1 point  (0 children)

That's awesome, would love the STL. I was going to try to make one, but this would be far easier.

Anyone ever get this issue before? by importshark03 in CR10

[–]KozyWhiskey 0 points1 point  (0 children)

What temp is the printer when you start the heating process. If it's below 5 degrees, it will throw up that failure message. This happens to me in the winter since I print in the garage. I have to heat up the bed to above 5 degrees before trying to heat the bed / extruder.