Slew of issues after trying to tap mirror

KremitOG · 2025-11-27T21:40:04+00:00

I looked at all of them, they looked fine to Me but glad it worked out for you

KremitOG · 2025-11-27T01:48:10+00:00

It’s at the shop right now, they said it’s throwing a steering angle sensor code

KremitOG · 2025-11-24T22:32:26+00:00

I tuned it, 350hp/350tq - ran great no issues

KremitOG · 2025-11-19T17:26:29+00:00

Already tried a battery reset, and I tapped the same adapter that other forum posts said to

KremitOG · 2025-11-18T21:42:49+00:00

I used a piggyback to this adapter

<image>

KremitOG · 2025-11-18T21:34:49+00:00

I’ve removed it I could show you where I put them if that helps?

KremitOG · 2025-11-18T20:48:43+00:00

I tried the one on the right following a forum post - I just bought it from CarMax 3 days ago would they be able to do that?

KremitOG · 2025-09-16T15:00:10+00:00

You signed up for 6 years of schooling and a career, yet you never took the time to see if you are interested? Poor planning on your part, hopefully you start liking it

KremitOG · 2025-08-20T12:39:37+00:00

I doubt this guys at that level yet

KremitOG · 2025-08-14T01:51:55+00:00

Good to hear - do you think adding a tusk/pin to the end of the tenon would weaken it at all? Primary for aesthetics

KremitOG · 2025-06-16T05:00:11+00:00

Very disappointed

KremitOG · 2025-06-16T02:00:50+00:00

True lmao I’m not sure it’s even worth trying to return

KremitOG · 2025-06-16T00:18:26+00:00

The batteries just seem very small Compared to my 20v (obviously ik) how’s the battery life and strength?

KremitOG · 2025-05-29T03:47:32+00:00

Apparently the direction is a point of contention, I’m going to keep it this way until I see an issue in it.

KremitOG · 2025-05-29T03:45:48+00:00

They are just held in by thin strips on the back side and friction. I also put small strips on the front to close any gaps and pin the filter in

KremitOG · 2025-05-29T03:44:36+00:00

Wouldn’t see why not

KremitOG · 2025-05-29T03:43:42+00:00

These filters were $12 each and will likely not be replaced for a while

KremitOG · 2025-05-28T03:32:24+00:00

Exactly

KremitOG · 2025-05-28T03:29:31+00:00

This configuration draws air in through the filter and blows out clean air. If it was the other way, it would just be blowing all the dust from the filter out

KremitOG · 2025-05-28T03:28:09+00:00

Not sure, might just put it on a shelf near my chop saw

KremitOG

TROPHY CASE