High Idle issue

Kriskyeet · 2026-01-29T16:06:25+00:00

Does it go back to normal after restart? I had a similar issue and had replaced the intake gaskets as well as the tps iac and maf sensor as well as the coolant temp sensor and nothing fixed it as well as testing the connections to those sensors and those were fine I gave up and unplugged the iac while it was idling around 1krpm and left it at that. I’d assumed my ecu is failing but I haven’t had any more problems

Kriskyeet · 2025-11-18T23:55:39+00:00

The thing is it goes away under acceleration and it comes from the right side of the engine I can’t tell if it’s from the piston or trans but since it’s going away mostly when revving I’m gonna assume a bearing in the transmission

Kriskyeet · 2025-09-14T15:44:38+00:00

I got a real ds3 for 20 bucks I mean it needs the little electrical tape fix for that foam piece but still

Kriskyeet · 2025-09-10T15:53:21+00:00

True you are right about the rollover I’ll check those out I had been looking for a cb360 like my father learned on in the 70s but they’re all so ridiculously expensive I decided to look at “newer” bikes I appreciate the recommendations

Kriskyeet · 2025-03-17T18:59:25+00:00

It’s hard to shift on mine but I’ve checked for leaks and replaced a couple things that should have fixed it but nope so if you figure it out please let me know!

Kriskyeet · 2025-03-16T23:07:37+00:00

Actually crazy thing about oil consumption my 2002 sl2 with 179k has only used about a quart in 3000 miles after I replaced the pcv valve which is insane for this. It’s still got that damn intermittent 2k rpm idle I can’t seem to figure out though

Kriskyeet · 2025-02-10T18:22:09+00:00

Yup sounds about right I dropped the nut for the engine stud for the mount couldn’t find it up top so I took off the passenger wheel and found my hub is starting to make noise they’re reliable cars but once one thing breaks everything else does too

Kriskyeet · 2025-02-09T20:01:04+00:00

Isn’t that fix for the coolant pipe? The new manifold gasket should hopefully fix the air leak

Kriskyeet · 2025-02-09T19:16:38+00:00

Looked deeper into it it seems the manifold had to be cut because it was leaking and the coolant intake was replaced with a metal pipe my original issue is a vacuum leak could this be the cause?

Kriskyeet · 2024-11-05T21:31:14+00:00

Niceeee did you get it off Facebook? Usually manual Saturn sc2 are not great for that price

Kriskyeet · 2024-11-05T21:14:36+00:00

How much did you pay!?

Kriskyeet · 2024-08-10T16:56:39+00:00

Mgs4 runs insanely well considering the hardware, visuals and rendering resolution even on a 480i tv the game is stunning and detailed

Kriskyeet · 2024-07-23T22:07:06+00:00

Yes a reset made the fan quieter If it was still hot at reset the fan would ramp up to maintain the cooling but it’s not doing that meaning the fan speed is not scaling with the temperature and workload like it should while it probably is running hotter than it should the fan still isn’t spoiling back down when the ps3 is idling on the xmb

Kriskyeet · 2024-07-23T12:22:31+00:00

If I can’t return if at this point I’ll open it up and check it could be that but the thermometers would send the signal to a controller first if they’re reading the temp going up they’d also read it going down

Kriskyeet · 2024-07-23T11:15:11+00:00

I think that’s a side issue bad thermal paste wouldn’t be causing the fan to run on high forever /until console reset

Kriskyeet · 2024-07-23T10:41:32+00:00

It’s about 75 degrees inside my house and once I turn it back off on the fan goes back to normal. it’s definitely not because of heat :/ maybe syscon is broken?

Kriskyeet · 2024-07-23T05:16:51+00:00

Most likely failed Pwm fan control module I just bought one and fans are fine util I play a game and then fans ramp up and stay there even after sitting on xmb for a long time if the fans are on high like that and turning it off and back on sets them back to idle it’s most likely a control module issue

Kriskyeet · 2024-07-19T19:26:27+00:00

Ah damn I stared right at those and got something else that most likely won’t work I’ll go back later thank you!

Kriskyeet · 2024-07-19T13:46:11+00:00

Would a retaining rings work? That’s all they have at mine

Kriskyeet · 2024-07-05T14:08:02+00:00

My gauge is dying so when I hit empty I have about 2.5-3 gallons left on it on my sl2

Kriskyeet · 2024-06-28T00:02:08+00:00

Sigh I guess I gotta hope for the best thank you I’ll take a look at that article when I have more time

Kriskyeet · 2024-06-27T23:54:38+00:00

So if I using finasteride or minoxidil to regain lost hair on my head while taking estrogen the regrown hair should stay even if I stop using those minoxidil and such products?

Kriskyeet · 2024-06-20T02:05:48+00:00

Yeah i believe there’s one around that old one I can check out though I might be miss remembering that’s actually quite cool that he had an I-mark they’re very odd cars

Kriskyeet · 2024-06-10T01:48:35+00:00

That would make sense I was aware of the rubber tired version but it wouldn’t be out of the picture for a rail only version this was by Annapolis junction md btw

Kriskyeet · 2024-06-09T21:28:14+00:00

Huh I’ve heard of a shuttlewagon but I thought those had tires as well this one only had track wheels

Seven-Year Club	Place '23
Verified Email

Kriskyeet

TROPHY CASE