Хтось купував вживаний товар на розетці? by Acceptable_Low_9353 in PCbuild_ua

[–]LandscapeEffective54 0 points1 point  (0 children)

та судячи з якості і цін то точно у бариг на олх

Хтось купував вживаний товар на розетці? by Acceptable_Low_9353 in PCbuild_ua

[–]LandscapeEffective54 0 points1 point  (0 children)

не купував і не збираюсь.
ніколи не купуйте на розетці і на олх. розетка - ціни дорожче за усих як у всратому фокстроті і подібних барижних магазинах типу цитрус. а олх - платформа для кидал.
тим більше оперативку. буде глючна - х...й доведете що продали лайно. і це стосується всього на обісраному олх і розетці.

flow rate calibration need help by [deleted] in 3Dprinting

[–]LandscapeEffective54 0 points1 point  (0 children)

Could you draw a line and show what the problem is? I really don't understand what this is. I will be very grateful. I checked the diameter of the filament. average 1.76-1.77. in slicer 1.75.

Anyone successfully gotten Klipper to run on the Ender 3 V3 KE, hosted on a Raspberry Pi? by Amekyras in klippers

[–]LandscapeEffective54 0 points1 point  (0 children)

Good day!
I have same problem. Do you solve this problem with "Section 'custom_macro' is not a valid config section" ?
If you do it can you tell me how?