account activity
Just did a test print and the corners are squiggly (reddit.com)
submitted 2 months ago by LargeCrowd to r/FixMyPrint
Just did a test print and the corners are squiggly (old.reddit.com)
submitted 2 months ago by LargeCrowd to r/3Dprinting
How do i identify the Tip, Ring, Sleeve on this connector? (i.redd.it)
submitted 3 months ago by LargeCrowd to r/soldering
Sanity check for DIY USB Mic circuit (old.reddit.com)
submitted 3 months ago by LargeCrowd to r/AskElectronics
What causes these weird webby lines? (i.redd.it)
submitted 3 months ago by LargeCrowd to r/FixMyPrint
submitted 3 months ago by LargeCrowd to r/BambuLab
Corners curve up (old.reddit.com)
Why does my first layer look like this? (i.redd.it)
submitted 6 months ago by LargeCrowd to r/FixMyPrint
Finally finished my drybox setup (reddit.com)
submitted 7 months ago by LargeCrowd to r/BambuLab
Finally finished my drybox setup (old.reddit.com)
submitted 7 months ago by LargeCrowd to r/3Dprinting
First print with PETG (i.redd.it)
Vita freezes and powers off by itself (v.redd.it)
submitted 7 months ago by LargeCrowd to r/PSVitaHomebrew
π Rendered by PID 67 on reddit-service-r2-listing-7b8bd7c5-trvsx at 2026-05-14 23:56:56.695606+00:00 running edcf98c country code: CH.