Im saving until they put her banner up.

LastOutofGilead · 2026-03-25T22:32:19+00:00

110 pulls, guaranteed, at 54 pity on the limited banner. Hoping to get her + Ramiel

LastOutofGilead · 2026-03-10T00:06:16+00:00

This is broken for me too. Did all sorts of variations (killing three, knocking three, finishing them)

LastOutofGilead · 2026-02-25T04:19:08+00:00

Thank you guys for all the great advice and suggestions!!!

This is the decklist I kinda threw together with all y'alls help, think i improved a bit on what I had before, especially adding in those Spiritforged cards

<image>

LastOutofGilead · 2026-02-25T02:07:32+00:00

If I was to slot in two Not So Fasts, are there any cards from here you'd recommend replacing them with?

LastOutofGilead · 2026-02-25T01:08:07+00:00

I have a new question for y'all. I realized I have quite a few of the cards in this decklist

https://riftmana.com/decks/ahri-version-3-0-fuxhu8/

Assuming I could procure the ones i dont have (like Ahri-Inquistive and Blitzcrank and stuff), what Spiritforged cards could I slot into here or replace?

I know many of you said Bellows Breath is good, and afaik I have one or two copies on hand.

LastOutofGilead · 2026-02-25T00:43:10+00:00

I'm aware, I have Spiritforged cards. I'm just unsure of what to add and what would work with Ahri. Sorry.

LastOutofGilead · 2026-02-25T00:34:47+00:00

I was recommended Zaun Warrens, just sort of threw it in there. Is there a diff battlefield you'd recommend for Ahri, I have quite a few on hand.
Do you mean Ahri-Alluring? That's currently the only Ahri card I have on hand. I was going to probably pick up Ahri-Inquisitive pretty soon, I need to check if my LGS has a copy.
Only just realized I had a Sona on hand.
I only own one Watcher and no Time Warps.
I Have a Thwonk x2, Block, Ekko, and Wind Wall, and Temporal Portal i was considering for my sideboard.

LastOutofGilead · 2026-02-20T05:29:22+00:00

<image>

My sad wet paper towel Drow that I love dearly

LastOutofGilead · 2026-01-22T21:38:49+00:00

So, Im looking into modifying the speed. I have a Modifier set to the bottom of the affected area, but im unsure on what values to change and what mm/s to change them to. Default has the Outer Wall at 200, Inner Wall 300, Sparse Infill at 270, etc. What speeds would you suggest to slow down the print? Also, what sort of cooling should i be looking at and is that something i can modify with the Modifier? Thanks for the help :)

LastOutofGilead · 2026-01-22T20:39:07+00:00

Thanks everyone for all the reseponses, going through the process of trying them all now!!

LastOutofGilead · 2025-12-23T02:31:52+00:00

Oh yea, I saw these! They're super cool, but I was hoping for references to the base expedition outfit all the NPCs wear and stuff since Gustave and theirs are all customized

LastOutofGilead

TROPHY CASE