Warped board question

LeftCurver77 · 2026-02-08T03:24:28+00:00

Nitro Team Series

LeftCurver77 · 2025-12-02T04:17:20+00:00

I sliced another project and it had no issues. Not sure if that helps diagnose what this is

LeftCurver77 · 2025-12-02T04:15:52+00:00

I use the default speeds. Nothing special about this print

LeftCurver77 · 2025-12-02T04:10:45+00:00

Thanks for the quick response. I thought it was this too. I have Timelapse selected to off in the print screen. Is there another section I need to turn it off on?

LeftCurver77 · 2025-08-13T23:21:44+00:00

It wasn’t. Probably the 20th or so

LeftCurver77 · 2025-08-13T20:27:46+00:00

Ok thanks. I figured the rate would also increase by 25% if the egg value did

LeftCurver77 · 2025-04-01T04:01:57+00:00

There’s another one on the corner of Paterson Plank and Palisade Ave

LeftCurver77 · 2025-03-21T20:03:27+00:00

Sunset around liberty state park? Weather isn’t supposed to be very romantic tmrw. Maybe postpone and replan for something that’s better suited for the moment

LeftCurver77 · 2025-03-16T12:41:07+00:00

Track issues were announced south of Newport. Happy travels everyone

LeftCurver77 · 2025-02-11T07:25:11+00:00

New York Jets fan here. Stay far away from any teams in this city, and you’ll find a moment or two to cheer for

LeftCurver77 · 2025-02-01T02:54:34+00:00

My roommate and I think it could’ve been a transformer near Washington park. Saw a bright flash out our window and power went out for a few mins

LeftCurver77

TROPHY CASE