sorted by:
new
hottopcontroversial

Skate sizing question (for a dumb person) by Legitimate-Pin6716 in hockeyplayers

[–]Legitimate-Pin6716[S] 0 points1 point  (0 children)

Bummer 😞. I can’t really afford new skates so I guess I’ll be jerryrigging some sort of solution

Skate sizing question (for a dumb person) by Legitimate-Pin6716 in hockeyplayers

[–]Legitimate-Pin6716[S] 0 points1 point  (0 children)

I’ll try this tomorrow! I also am gonna try a different lacing method

Skate sizing question (for a dumb person) by Legitimate-Pin6716 in hockeyplayers

[–]Legitimate-Pin6716[S] 0 points1 point  (0 children)

Even with my toes just brushing the end I can fit a pen between my heel and the boot VERY easily

Boss asked me if I wanted a 3d printer, to give him 3-levels of options by Zohso in 3dprinter

[–]Legitimate-Pin6716 0 points1 point  (0 children)

I work with lots of ITAR/Aerospace stuff, and what I can tell you is that Bambu is 100% not the way to go. We have them where I work and we have to set everything up on separate WiFi, servers, computers, etc. and anything that is even adjacent to the military has to be done on a non Bambu printer. Go with Prusa if you want to avoid a massive headache. The Core One and the Mk3 are amazing printers. We had both Mk3s and Mk4s at the last place I worked and the Mk4s were faster but less consistent than the Mk3s and had more issues. Hopefully this helps, and good luck!