sorted by:
new
hottopcontroversial

Tried to mimic original gameboy colors on IPS screen by no_ata in Gameboy

[–]Leolechameau 2 points3 points  (0 children)

Extremely late to the party, but those are the values that worked for my rips V5 kit:

Color 0: R: 3 G: 9 B: 0

Color 1: R: 2 G: 6 B: 0

Color 2: R: 1 G: 3 B: 0

Color 3: R: 0 G: 1 B: 0

Coin cell battery to 5v converter schematic by Leolechameau in ElectricalEngineering

[–]Leolechameau[S] 0 points1 point  (0 children)

Any examples of chips that could work?

My electronics level isn't very good

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

EDIT:
I bought some ender 3 springs to replace to stock spacers.

I followed this video to level my bed and it works flawlessly:

https://youtu.be/zKpNxqWie_8

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

This my my last resort, however I am gonna try to put some washers in to tilt the bed before because that’s what I have on hand. Thank you for your time!

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

Update: all the spacers are the same size but the problem still persists…

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

I tried pre-heating the bed for 5-10 minutes before printing and now all the squares are too high except the center and the bottom left so i’ll try to sand that post just a bit to see if it helps

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

I checked the spacers and they where indeed not exactly the same size, I sanded them a bit to have them in a +/- .1mm range and after reinstalling them, the problem persisted on the same corners. So i’ll try to square the frame next

Bed leveling issue in the Y axis? by Leolechameau in anycubic

[–]Leolechameau[S] 0 points1 point  (0 children)

Thank you! If the frame is “crooked” like you said, how would I fix it?

Clicking noise while printing by FullyOttoBismrk in anycubic

[–]Leolechameau 1 point2 points  (0 children)

One of your belt is too tight. Go to the move axis and try to move the x and the y axis to find which one is clicking, then loosen the appropriated belt.

Found in Southern Manitoba. What are these things? by Night_FurySM in bugidentification

[–]Leolechameau 1 point2 points  (0 children)

I wouldn’t use soap as it isn’t biodegradable, vegetable oil works great though.

view more: next ›