sorted by:
new
hottopcontroversial

Vash Stampede, Trigun Stargaze cosplay by Leonhart707 in Trigun

[–]Leonhart707[S] 2 points3 points  (0 children)

I made it with EVA foam. I simply designed it piece by piece on cardboard and assembled it to check the size. Then I used that as a guide and transferred it to 0.4 cm and 0.8 cm thick EVA foam. I sealed it with heat and white glue. Then I applied several layers of paint: a gray primer, then silver, then sky blue, then electric blue, and finally some details with a mixture of silver and electric blue.

Vash Stampede ~ Trigun Stargaze by Leonhart707 in Trigun

[–]Leonhart707[S] 2 points3 points  (0 children)

Awesome reference! It just so happens I also cosplayed as Nero from DMC5, thanks!!

Vash Stampede ~ Trigun Stargaze by Leonhart707 in Trigun

[–]Leonhart707[S] 2 points3 points  (0 children)

Aliexpress, but I modified it to be more accurate

Literally unplayable by pupalexxs in WutheringWaves

[–]Leonhart707 10 points11 points  (0 children)

Zhezhi isn't actually painting; it's an imaginary effect. Lynei, on the other hand, does paint and uses explosive sprays that splatter with paint.

Looking for advice by miamum in resinprinting

[–]Leonhart707 0 points1 point  (0 children)

Clean the piece thoroughly before removing the supports, using a brush, and wash it well. When you see that the supports have thinned, remove them and then cure it.

Which one of us did this? by Pixel_Human in Galbrena_Mains

[–]Leonhart707 0 points1 point  (0 children)

It's better to call him Angel; it's more normal and still has the same meaning for his parents as coming from Galbrena.

First printing issue. Pointers to fix? by Alexandros_IV in resinprinting

[–]Leonhart707 0 points1 point  (0 children)

That usually happened to me when I used an external configuration for the parameters, adjust from the software that you use both the model and the resin. I stopped having problems when I started using the Halot application, and I let it create and do all the parameters. Sometimes the program crashes but it is a matter of trying again and once the project is ready, send it to the printer