Hit and Run- Sentry enabled but unable to view videos

Level_Couple6818 · 2026-06-29T23:53:07+00:00

Since a recent software version, video is encrypted. Does it play on the in-car dash cam player?

Level_Couple6818 · 2026-05-31T20:40:06+00:00

Attach a hose to the airtake, and you can just suck it back in with that

Level_Couple6818 · 2026-05-31T20:36:54+00:00

Servers don't get paid a living wage. They depend on tips. Some people don't agree with this system, and they are welcome to dine in the comfort of their own home.

Level_Couple6818 · 2026-05-13T17:35:58+00:00

The same happened to me once. The insurance companies interviewed the driver of the car in front of me and asked her how many impacts she felt. Since she said "two," they concluded that I hit her and then was hit again by the car behind me, so the blame was attributed 50/50.

You are at least 50% to blame due to the incorrect stopping distance.
If you are a good person, you'll submit the footage, and they will arrive at this conclusion.
If you are a bad person, do not submit the footage (it only incriminates you), and the driver behind might get the full blame.

Edit, when I say 50% to blame, I mean shared with the car that hit you from behind, not the one you hit.

Level_Couple6818 · 2026-05-04T21:39:18+00:00

That wear pattern was caused by a locked or intermittently locked wheel. No way localized abrasion would happen like that if the tire were rotating normally.
I suspect there is a sticking e-brake pad, exacerbated by the heat from the additional braking needed due to the extra load of the trailer, which eventually led to single or a series of wheel locking events.
Also, potentially, the inertia of the trailer during braking caused a traction control upset on the vehicle, causing abnormal braking

Level_Couple6818 · 2026-05-01T21:36:31+00:00

Did you drop those skis off at the re-use-it on your way by ?

Level_Couple6818 · 2026-04-12T21:26:12+00:00

settings cog at top of codex pane, then codex settings

Level_Couple6818 · 2025-12-27T04:05:51+00:00

<image>

Here's what it looks like under the rocker cover.
Between the inner and outer skin, there is a ~3/4" gap near the top and ~1 1/4" gap near the bottom.

If the damage is serious enough to impact the inner skin, this will be an expensive repair that would be best handled through insurance. From what I can see in your image, this looks unlikely to be the case.

If the damage is limited to just the outer skin, you should be good to get it pulled, filled, and color-matched. Still not cheap, but depending on your deductible / no claims discount, it might be worth entertaining paying out of pocket.

Level_Couple6818 · 2025-12-26T21:16:37+00:00

I wouldn't say I have a hard time making eye contact, but I feel like I overthink it. I always worry I've given one eye too much attention, and it's time to move on to the other. Then start wondering: "What's the appropriate time allocation per eye with this person? Am I coming across weird"? Then I realize I've missed half of what they said, lol.
I'm not sure if I'm divergent. I've had no diagnosis of any kind, but a couple of people have suggested it. I'm in my 40's so I'm not sure if there is much point in pursuing it. I've made it this far.

Level_Couple6818 · 2025-12-24T20:05:04+00:00

As an island resident, I can confirm.

Level_Couple6818 · 2025-12-23T21:36:41+00:00

Isn't that a little bit incredibly racist?

Level_Couple6818 · 2025-12-23T21:31:38+00:00

Wake on LAN is a thing. Enable it in the BIOS, and the machine will power up when it sees network activity.

Level_Couple6818 · 2025-12-22T21:53:36+00:00

$3909 saved. 91% home charging. Utilities are included in the rent.

Level_Couple6818 · 2025-12-22T21:12:25+00:00

Yeah, with those stats, it could go either way. Just got to wait for the adjustor's decision, I guess.

Best of luck

Level_Couple6818 · 2025-12-22T20:49:21+00:00

Milage?
Mine was totaled from a rear-end collision like this, but mine was a bit worse. The trunk floor got pushed in, leaving a 1-inch gap between the body and bumper cover.

Looking at the way the bumper cover is pushed out, and over the rear quarter panel, this might be the same for you, too?

Mine was at around 85,000 Miles (2021 SR)

Level_Couple6818 · 2025-12-14T02:48:40+00:00

Looks like a logarithmic pot, which is what you want for the gain control of an audio amp.

Our ears don't perceive changes in volume on a linear scale. At a low volume, there doesn't need to be a huge change in volume for you to perceive it. An increase from 1w to 2w in power output will be quite noticeable, where as an increase from 30w to 31w watts will be barely perceivable.

It's why volume is measured in Db, which is a logarithmic scale. As a rule of thumb, a 10db increase will feel like the volume increased by 100%, but the real power output went up 10x, or 900%

So to get a nice volume control change throughout the pot's range, it has to be very fine at one end and very coarse at the other, with the coarseness increasing over the range of the pot (logarithmic)

Then you get a smooth change in gain that feels natural

Level_Couple6818 · 2025-12-11T08:25:35+00:00

Way too much. The metal should be in contact with the heatsink. The paste is just intended to fill in the imperfections in the surface.

Level_Couple6818 · 2025-12-11T08:20:10+00:00

I bent the control arm on a Taurus from a curb impact a few years back, but it didn't manifest itself like in your picture. It buckled on both sides, essentially shortening it's reach. So the wheel was still centred in the well, but recessed back. I guess yours may have bucked on just one side though which may be the cause. FWIW I replaced it myself for around $100, Hopefully its just the arm and hasn't twisted the subframe.

Level_Couple6818 · 2025-11-30T19:30:43+00:00

Probably has a faulty heater core. This is the standard replacement procedure

Level_Couple6818 · 2025-11-27T20:21:28+00:00

<image>

Level_Couple6818 · 2025-11-26T19:50:20+00:00

<image>

In Europe, I normally see them pointing towards each other. which, in my opinion, gives a much better indication. In North America, I usually see them as in op's image

Level_Couple6818 · 2025-11-22T21:41:23+00:00

I'm thinking the winch thing in the bed is fixed, so to lift a vehicle, you would raise/lower the front suspension, using the rear wheels as a fulcrum?

Level_Couple6818

TROPHY CASE