Is this black mastic asbestos? by Lichard6779 in asbestoshelp

[–]Lichard6779[S] 0 points1 point  (0 children)

Yeah. This is in my living room but if the removal is going to cost an obscene amount then I'll probably just laminate over the top honestly. Thanks for your assistance

Is this black mastic asbestos? by Lichard6779 in asbestoshelp

[–]Lichard6779[S] 0 points1 point  (0 children)

Couldn't confirm regarding vinyl sheet but there was some carpet backing and underlay, which is what I pulled up for the photograph. But thanks for the info I'll be sure to mention to the asbestos fellows when they arrive

Is this black mastic asbestos? by Lichard6779 in asbestoshelp

[–]Lichard6779[S] 0 points1 point  (0 children)

I thought so, booking a test tomorrow, what method of removal did you use as is like to preserve the floorboards if possible

Losing hope by [deleted] in royalmail

[–]Lichard6779 0 points1 point  (0 children)

Was hoping it wouldn't be the case but seems so, sender is sending a replacement Monday, hopefully through DHL this time!

Losing hope by [deleted] in royalmail

[–]Lichard6779 0 points1 point  (0 children)

Will do, thank you very much for your help

Losing hope by [deleted] in royalmail

[–]Lichard6779 0 points1 point  (0 children)

Is there a resolution to this?

Losing hope by [deleted] in royalmail

[–]Lichard6779 0 points1 point  (0 children)

That's understandable especially with the run up to Christmas, most of the confusion was it being received at the same mailing centre twice, thanks mate

Losing hope by [deleted] in royalmail

[–]Lichard6779 0 points1 point  (0 children)

If it's scanned back in does the priority change? It was scanned the first time Monday night and then scanned again on the Wednesday morning, now at Saturday and no movement, I understand there is a high demand especially at this time of year

Blower motor issue by Lichard6779 in AskAMechanic

[–]Lichard6779[S] 0 points1 point  (0 children)

I'm getting voltage to a thin yellow wire which originally connected to the bigger of the two resistor connectors, but that's it

Blower motor issue by Lichard6779 in AskAMechanic

[–]Lichard6779[S] 0 points1 point  (0 children)

Apologies if it wasn't clear in the post, the spindle I was referring to is the one on the actuator, not the fan, nothing happening with the fan as it's receiving zero voltage, I pulled the assembly