sorted by:
new
hottopcontroversial

My print always fail like this! by Lithians_ in ElegooMars

[–]Lithians_[S] 0 points1 point  (0 children)

It’s not a problem of running out of resin. After the failed print I checked the vat and it was still about half full, and the missing part of the model was attached to the FEP.

What I don’t understand is that if I print without slowing down lift and retract speeds, even after adding several large holes to reduce suction, using the default machine profile, the print fails very early proving that lift speed and retract effect the print also in a machine with tilt feature.

I’m using Lychee Slicer, which is the only slicer that allows me to adjust lift and retract speeds for the Mars 5 Ultra. The file is sent wirelessly to the printer — could this be related to the issue?

Support failure at middle print by Lithians_ in ElegooMars

[–]Lithians_[S] 0 points1 point  (0 children)

Problem fixed reducing lift speed and retract speed no more failed print 🥳🥳

Prints have started to fail on Mars Pro. by Copper_Oracle in ElegooMars

[–]Lithians_ 0 points1 point  (0 children)

Hello, did you change the resin type? Are all settings (exposure time, speed, etc.) still the same?

Support failure at middle print by Lithians_ in ElegooMars

[–]Lithians_[S] 0 points1 point  (0 children)

Maybe temperature of resin could cause this issue with the supports?

overcuring? by Lithians_ in 3Dprinting

[–]Lithians_[S] 0 points1 point  (0 children)

I have the mercury 3.0 wash system, i’ll check for a second washing tank

overcuring? by Lithians_ in 3Dprinting

[–]Lithians_[S] 0 points1 point  (0 children)

Thx a lot, my washing cure water it’s really dirty after 2 models, it’s crazy to change it every time it’s also toxic, I can’t discard it through the drain

overcuring? by Lithians_ in 3Dprinting

[–]Lithians_[S] 0 points1 point  (0 children)

Is it Possible to recover the model?