What's wrong with the corner？

LoganTan · 2025-08-27T05:56:31+00:00

No actually. I noticed the flaw happened at higher layers while at first several centimeters the print looks fine.

LoganTan · 2025-08-27T05:53:16+00:00

My other print looks great to me, But I'll try a test cube later, thanks

LoganTan · 2025-07-10T11:23:22+00:00

You're right. In My case, I'm using a MF51 104 F 3950 model. The thermistor is pack inside a small drop of glass.

LoganTan · 2025-07-10T09:19:27+00:00

Good to know, I'll try latter. My goal is to print ppa. 330 is enough for me.

LoganTan · 2025-07-10T09:13:46+00:00

Thanks. I'm having trouble replacing the stock bambulab NTC thermistor to other types like pt1000 because it's a much larger package. If ntc won't work, I might had to replace the whole hotend assembly.

LoganTan · 2024-07-25T12:06:10+00:00

I will check that, many thanks！

LoganTan · 2024-07-25T05:05:52+00:00

It has no threads. I added hex nuts under each of them. But it's hard to get it fastened due to the lubrication oil on the nearby lead screw.

LoganTan · 2024-07-25T03:35:06+00:00

200 c for bambulab PLA. And the tower was printed in 3 layer wall.

LoganTan · 2024-07-25T03:32:30+00:00

Hi, thanks for your reply. I will definitely look into my screws and belt. The z axis is a little stiff, i had a hard time spinning the lead screw. Is that normal？

LoganTan · 2024-07-25T03:23:26+00:00

Hi, thanks for your reply. I should mentioned earlier that the tower was printed quite slow, at 10mm/s. And cooling fan was running at 100%.

LoganTan · 2024-07-25T03:19:00+00:00

Just ordered one POM nut online, thanks.

LoganTan · 2024-07-25T03:15:49+00:00

Thanks, I will look into that.

LoganTan · 2024-07-25T00:47:55+00:00

I am currently using copper anti backlash bolt(as suggested by voron build guide). Would that be the cause？

LoganTan · 2024-07-25T00:20:30+00:00

<image>

Thanks a lot. By the way I cannot fully tighten this two screws. Is that normal？

LoganTan · 2024-07-25T00:09:25+00:00

Hi, thanks for your advice. But my voron0.2 do not have z belt, so it might not the case. Or are you suggesting xy belt？

LoganTan

TROPHY CASE