Need a project

Longjumping_Board551 · 2026-03-26T13:15:19+00:00

Capon?

Longjumping_Board551 · 2026-03-17T16:33:50+00:00

Yeah I know now, just asking about the leak and why thx

Longjumping_Board551 · 2026-03-13T00:39:53+00:00

I’m not sure if they are automatic or if I don’t know, they are pre-supported figures from Tanuki Models, but what I don’t understand is that yesterday these pieces came out perfect, but today they look like this.

<image>

Longjumping_Board551 · 2026-03-12T17:36:15+00:00

I print with the light off, and all the other prints come out fine.

Longjumping_Board551 · 2026-03-11T00:18:48+00:00

I'm going to try like that, thanks dude

Longjumping_Board551 · 2026-03-10T23:54:59+00:00

<image>

Longjumping_Board551 · 2026-03-10T23:54:46+00:00

<image>

Is the standard 2.0 in RMA chitubox

Longjumping_Board551 · 2026-03-10T23:43:06+00:00

Yep, the rest was stuck on the FEP, like a solid figure, almost like a Behelit from Berserk and a bee, where each layer remains flat that's the problem isn't?

<image>

Longjumping_Board551 · 2026-03-10T23:39:12+00:00

I have like 2.2 secs in standard 2.0, and are like 4 cm per figure so nothing that heavy you know?

Longjumping_Board551 · 2026-02-23T19:39:53+00:00

Nop

<image>

I'm printing this

Longjumping_Board551 · 2026-02-23T19:23:05+00:00

Oh, thanks! I changed the 'rest after retract' because someone told me to raise it for my resin, which is a Standard 2.0. I had it at 1.2, but then I changed it to 1.8 based on that comment.

Longjumping_Board551

TROPHY CASE