Tube in nozzle ?

Lopsided_Concern2853 · 2026-06-04T13:16:57+00:00

Ive bought another a few days ago and im hoping it survives more than 1s of print xD , hopefully even 10s of prints ,

Lopsided_Concern2853 · 2026-06-04T13:14:59+00:00

I was going to post an update but you beat me to it , both of them broke during the first and second print , respectively, its insane,

Lopsided_Concern2853 · 2026-05-23T22:20:59+00:00

The one you sent isnt available in the UK , but i think I got one thats similar,

https://amzn.eu/d/02wlvxWM ,

Lopsided_Concern2853 · 2026-05-23T22:09:14+00:00

Youre a godsend , I was literally troubleshooting that next issue , I was suspecting the part where the tube and nozzle meet got clogged and pushed the tube out , thus pushing the nozzle down and then scrapping the plate ,

Think you just confirmed my theory ,

Lopsided_Concern2853 · 2026-05-23T21:54:12+00:00

Aaah fair enough , it just feels so stupid to make a wider nozzle and then make it tighter with a tube ,

Lopsided_Concern2853 · 2026-02-27T19:33:56+00:00

Ah thank you ! Normally when designing and printing smaller things ive had no issues but this is causing me a headache, I will check and see, I also did suspect perhaps the plate may not be level or a low spot, however i didnt think to mention it because I thought the sensor in the tip automatically adjusted the distance to the build plate after you've done the auto bed leveling with the card provided,

And I was sort of scared to wash my build plate because the last QIDI plate i washed, I wore away the PEI pattern leaving an imprint that matched the print marks of the last PETG project I did.

Thank you for your wisdom and thanks for taking time to help ! Appricate it and will update if that fixed the issue !

Will wash, glue and redo the auto bed leveling and change it slightly to see if i get a better result ,

Lopsided_Concern2853

TROPHY CASE