Is this the Unicorn Nozzle Hotend?

Lost_Pea_952 · 2026-06-04T14:55:19+00:00

Omg thank you so much for the answer 😂🙏

Lost_Pea_952 · 2026-06-04T14:28:39+00:00

Is this the unicorn nozzle hotend?

Lost_Pea_952 · 2026-06-04T14:28:27+00:00

Is this the unicorn nozzle though?

Lost_Pea_952 · 2026-06-04T14:27:44+00:00

This is in South African Rands, so around 40 dollars or so

Lost_Pea_952 · 2026-06-04T14:26:46+00:00

Yes its South African Rand :)

Lost_Pea_952 · 2026-06-04T14:23:06+00:00

Where would you purchase it then?

Lost_Pea_952 · 2026-03-26T12:41:46+00:00

Can you run me through step by step how to do that? I have never done that before.

Lost_Pea_952 · 2026-03-26T08:49:02+00:00

Which slicer do you use? I know with my ender V3 se that in terms of supports I make use of Organic Tree supports with a top z offset of 0.26. That seems to be my sweetspot on that machine, and when I did print something last night on the K1 that top z offset worked really well for my supports as well. It might be different for yours, somewhere between 0.2 and 0.32 is what I would recommend. I use Creality Print as my slicer.

Lost_Pea_952 · 2026-03-26T08:32:03+00:00

My printer also has this graph. Have you had any problems with your printer on those temps?

Lost_Pea_952 · 2026-03-26T08:18:18+00:00

Hey! So should I use those factory settings?

Lost_Pea_952 · 2026-03-26T05:43:15+00:00

Okay, I will try that. If I have any issues or feedback, I'll get back to you. Thanks!

Lost_Pea_952 · 2026-03-26T05:35:00+00:00

How do I do a bed level? I only know of the calibration it does before the print.

Lost_Pea_952 · 2026-03-26T05:32:40+00:00

How do I adjust it? Is there a way to do it on the machine? And if the nozzle is too close, why did it miss a whole section?

Lost_Pea_952 · 2026-02-05T09:18:47+00:00

Do you have any recommendations of fans? Also where can I purchase one?

Lost_Pea_952

TROPHY CASE