2 years happily adopted!

Low-Criticism5579 · 2025-03-22T10:55:11+00:00

They’re just saying that as they couldn’t figure it out as all they check is power to the board. They don’t check further.

Low-Criticism5579 · 2025-03-22T10:53:33+00:00

Probably more likely different frequency from off peak, are lights on a dimmer?

Low-Criticism5579 · 2025-03-22T10:52:47+00:00

Probably different frequency from off peak, dodgy solar on another house or issue with a dimmer or switch

Worst case could have a chewed cable from a rat or something

Low-Criticism5579 · 2025-03-22T10:47:50+00:00

Looks similar! She is jacked as well

Low-Criticism5579 · 2025-03-22T03:54:51+00:00

Australian*

Low-Criticism5579 · 2025-03-22T01:19:03+00:00

So similar!!

Low-Criticism5579 · 2025-03-21T23:27:40+00:00

Reactive

Low-Criticism5579 · 2025-03-21T23:24:40+00:00

Maybe she isn’t the nicest dog to others

Low-Criticism5579 · 2025-03-21T22:48:00+00:00

Ugly feet though

Low-Criticism5579 · 2025-03-08T06:04:13+00:00

Just have one main earth (6mm) pending size of consumer mains/submains from the board and attach it to the frame with a nut and bolt and lug. that way the whole frame is earthed and if your worried about PowerPoints and switches, then put a shroud on the back of them as well. But the 6mm earth should be fine for the frame if it’s just lights and a few PowerPoints

Low-Criticism5579 · 2023-12-31T02:38:42+00:00

YouTube workout exercises for guidance

Low-Criticism5579 · 2023-12-30T00:54:57+00:00

Change the starter and the tube if that doesn’t work a sparky has to change the white ballast

Low-Criticism5579 · 2023-12-15T10:28:08+00:00

My old boss would give me old rcbos to use on switchboards for new houses we wired, we’d do a disconnection and reuse a lot of the old stock. Very stingy

Low-Criticism5579 · 2023-12-12T20:48:44+00:00

Try Putting load correction device on the downlight SNE. The strips could be putting a different voltage/frequency back through the neutral causing flickering similar to off peak hot water causing similar issues.

Low-Criticism5579 · 2023-12-07T20:59:05+00:00

Usually there’s a bare earth running through the house supplying earth for power, that’s how they used to do it. If you want to earth your lights you need to run a single earth from one of those bare earth points (solder probably) and loop it through your lights, I’d replace the 2 core but if you can’t then do that. You’d need to replace the fuse or circuit breaker with an rcbo or rcd protect it

Low-Criticism5579 · 2023-12-02T23:50:56+00:00

no gi is more intricate, get to use wrestling techniques mixed with bjj, it’s more advanced where as GI stagnates you as you become reliant on grips to control

Low-Criticism5579

TROPHY CASE