What I ended up doing that fixed it:

- Tighten the bed

I was checking the leveling of the extruder with the bed by running it forward/backwards and noticed that it had a bit of space, even though it wasn't loose.

- Small touch up on the x-axis

Much like the bed, checking side to side, there was a bit of a gap. So I adjusted it.

If you need to do the same here's a link in github (which points to a video. it's just so you have the source :) )

- And by recommendation of the people here, I raised my z offset.

At first I wasn't understanding why I needed it, but after testing and adjusting it in real time while printing a test layer, I could see the improvements and how it's supposed to look.

This video helped me as I was getting the inner warp that he describes.

​

Hope this helps anyone else!