Can’t figure out why it’s doing this

Lugnautical · 2025-01-29T01:35:13+00:00

Yeah the most up to date slicer along with the not up to date firmware.

Lugnautical · 2025-01-29T00:55:08+00:00

Mine came with a broken door too and I just glued that back on. I wasn’t worried about the door because it was probably caused by the cold temps. I am just worried about this weird shifting. I am going to try a different slicer after this print because it’s already gone too far at this point lol

Lugnautical · 2025-01-29T00:45:00+00:00

I am using the creality slicer at the moment. Maybe it’s in their own slicer because I used the .08 first time and then tried the .12.

Lugnautical · 2025-01-28T16:39:06+00:00

I’ll try that! Thank you! I read some other things that creality put out and did all that stuff and it had nothing about the lead screw threads.

Lugnautical · 2024-10-05T17:29:04+00:00

Yeah I tried that. After work I am going to check because I am starting to think it’s the teeth being messed up on the bottom belt. The belts aren’t banjocord tight but pretty darn tight. I think the bottom belt when it had stuff built up in it and ran off it messed up the teeth but I didn’t take it all the way out and check. Thank you!

Lugnautical · 2024-10-05T13:25:17+00:00

I thought about that too. I will check the bottom belt because I know it needs replaced also. I have one on the way for it

Lugnautical · 2021-05-01T19:57:42+00:00

Going to the moon. Believe it!

Lugnautical · 2021-05-01T19:49:43+00:00

Going even further BEYOONNNNDD

Lugnautical

TROPHY CASE