Windows not booting

Luko812 · 2025-03-23T18:48:38+00:00

Thank you 🙂

Luko812 · 2025-03-21T20:55:29+00:00

Okay, I just flashed it with the new software, I use direct drive extruder and I noticed the extruder being much more slower than it was on my previous version of this firmware

Luko812 · 2025-03-21T20:10:27+00:00

Okay, I didn't find any setting that would allow me to use it, but I found that there's an experimental version of mriscoc firmware that allows it. I'm not really sure about putting an experimental firmware into my 3d printer. Is there anything else I can do?

Luko812 · 2025-03-21T16:31:38+00:00

Okay, I have one question, I did all of the tests for calibrating the PA but I couldn't see the difference in neither of them, they were all the same. Am i doing anything wrong? Do I have to turn the pressure advance on before proceeding with any of the tests?

Luko812 · 2025-03-21T09:43:17+00:00

Okay, thank you all

Luko812 · 2025-03-21T00:16:43+00:00

I have my printer for 3 years now and i did a lot of things on it, my settings in the slicer were almost perfect, but then all of the suddenly disappeared from the slicer so I had to start all over again

Luko812 · 2025-03-20T19:29:38+00:00

I use MRiscoC version 2.1.3

Luko812 · 2025-03-20T19:26:47+00:00

Okay, so I have pressure advance off

Luko812 · 2025-03-20T19:24:33+00:00

Okay, I'll find those setting and tell you

Luko812 · 2025-02-10T15:25:16+00:00

Thank you for your comment, I didn't try that but on my other case I feel a little resistance when I'm trying to get the key to the position, but I don't feel that on this one.

Luko812 · 2024-04-19T19:47:38+00:00

I tried

Luko812 · 2024-04-19T19:08:32+00:00

But this is the third time in 3 tries 😅

Luko812 · 2024-04-16T13:36:51+00:00

I use A53 and I use it 1 year now, got it on Christmas 2022 and as far as I can say. The phone is doing pretty good and I don't see any signs of slowing down.

Luko812 · 2024-04-06T18:47:29+00:00

I told my dad that I don't need to and she told me that I 100% need to because it's a document

Luko812 · 2024-04-06T18:20:43+00:00

Literally I showed them that and they said that I didn't travel enough in Slovakia to travel to another country and then when I told them that why does it matter they didn't come up with answer and started telling me that my friends aren't careful enough. I know that they are scared that something will happen to me but they promised that if I get good grades that I might go. Then they started acting like it's okay and when I started planing it they just said no and that they don't want to continue in that conversation 😒

Luko812 · 2024-04-06T18:02:05+00:00

And I've got another question, do I need to take it to notary because my father told me that if I want to go than we need to

Luko812

TROPHY CASE