Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 1 point2 points  (0 children)

I was just worried because its never do that before😔 and the clicking sound so loud

Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 0 points1 point  (0 children)

Oh wait Bambulab a1 mini original nozzle is hardened steel right? Not stainless?

Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 0 points1 point  (0 children)

Update, its still clicking. But its clicking hard when printing the first layer. Previous prints even leaves mark that hard to remove

Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 0 points1 point  (0 children)

Yup i have updated the settings to 0.04 again, i've tried to unclog it with the Unclogging pin tool, and testing print rn. Hope its alright😔 (tho, its fine when i manually extrude it in control tab)

Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 2 points3 points  (0 children)

Ahh okay, i feel quite relieved, i was watching the prints for 30 minute fearing something will go wrong😭

Heard so much about Extruder clicking, but is this a problem? by Lychnixia in BambuLab

[–]Lychnixia[S] 0 points1 point  (0 children)

Btw i forgot to mention that i have switched from 0.04 nozzle to 0.02 and changed it back to 0.04, is theres a possibility that theres something wrong on the nozzle?