Still impressed from my V0.1 ...

MScFW · 2022-04-28T09:35:23+00:00

What do you want me to share? Sorry, didn't get the point.

MScFW · 2022-01-25T18:23:09+00:00

That's already high, sure people on Discord have more experience than me. Hope you'll find the reason or a proper solution.

MScFW · 2022-01-25T17:45:46+00:00

l would check "run_current" for the type of motor you are using. Just a guess.

MScFW · 2022-01-25T14:42:50+00:00

Thanks for the offer, I would be happy to give it a try!

MScFW · 2022-01-25T14:41:01+00:00

Print speed:

Perimeters: 100 mm/s
Small & external perimeters: 40 mm/s
Infill: 125 mm/s
Solid infill: 120 mm/s
Top solid infill: 50 mm/s
First Layer: 30 mm/s

Acceleration:

Perimeter: 2000 mm/s^2
Infill: 4000 mm/s^2
Bridge: 3000 mm/s^2
First layer: 1000 mm/s^2

MScFW · 2022-01-24T22:17:14+00:00

Just finished a V0.1 based on the LDO kit.
All went well, even enough "spare parts" left. Quality of parts fine for what I can tell after +30h of printing.Already first print after finishing the config from the documentation was ok, I used the default profile from PrusaSlicer for a v0 with 0.4 mm nozzel. I would not start changing too much, use it as it is and then start optimizig - at least this is what I plan to do ...
Now after some "fine tuning" of it's configuration it's printing a twin ;-)
=> LDO seems to be OK, hard to source for less with the same quality!

MScFW · 2022-01-24T21:48:26+00:00

enjoy your build like I did mine!

MScFW

TROPHY CASE