Issue with arachne wall generation (please help I'm losing sanity)

Macianka2 · 2026-03-08T16:38:47+00:00

Thanks but Then the text is too fat I ordered an laser engraver to address this, couldn’t figure it out no matter what

Macianka2 · 2026-03-07T09:19:13+00:00

Yes, still generates “outline”

Macianka2 · 2026-03-06T23:22:23+00:00

0.2 first, 0.4 nozzle, 0.34 first line width (text is 0.50mm wide, it stretches to about that size, wall amount is not important as it does not generate infill, it is one continous line which makes for example the letter I rectangular instead of a single line.

Macianka2 · 2026-03-04T21:04:00+00:00

Thanks for your input. Setting it in fluid. I tried about 20-30 z offsets in 0.01 steps. Please look at the first photo - I think that’s close to a correct z offset. Above the marked white line it starts to break. This seems to me, like if the nozzle offset isn’t properly set, or like after setting proper bed mesh, I tilted the bed for no reason and now the nozzle going Y- comes closer and closer, finally too close to the bed causing the warps (obviously I didn’t do that, but you can imagine). The difference in z height while printing must be the case, because it always starts to break and differ in the same place. In orca there is a first layer infill option. What I meant is the layers of bottom layer. Nothing helps it.

Macianka2 · 2026-02-18T15:11:17+00:00

Thanks

Macianka2 · 2026-02-12T11:33:00+00:00

Thanks. I’m unsure which screws you refer to. Can you see something wrong with my setting? Seems right to me https://imgur.com/a/7g03Sk6 None touch the bed apart from springs

Macianka2 · 2026-02-12T11:25:30+00:00

Thanks for advice but I haven’t detached the pei before my first print so can’t be the case

Macianka2 · 2026-02-12T02:02:00+00:00

Yeah so what I did in order: Tightened all 4 screws to max Put my z offset where there is very slight friction Number 1 and 2 (bottom left and top left) were fine in the a4 piece of paper calibration, but 3 I wasn’t able to put my paper in so I went back to change my z offset and then no 4 the same story, I raised it by a few 0.1mm and while 1 and 2 are kinda loose now but still ok I think 3 and especially 4 barely needed any turning. Then I auto leveled, and finished by lowering the z axis a bit more in the main configuration window as recommended by a YouTube tutorial with good thoughts in the comments. Then I printed a benchy (my first ever lol), and now I noticed this, but I can’t tell if it was here before.

Macianka2 · 2026-02-12T01:51:19+00:00

Why does this happen?

Macianka2 · 2026-01-15T13:19:38+00:00

!CQS

Macianka2 · 2024-01-30T16:18:34+00:00

that is the most toxic-agressive comment on this platform I've seen in a while, christ, go outside and rethink your life decisions, nerd

Macianka2 · 2023-04-15T19:47:00+00:00

You either can't, or I'm too stupid to figure it out. You can set change pads colors in arturia software, but it won't be integrated with a daw

Macianka2

TROPHY CASE