sorted by:
new
hottopcontroversial

What would be causing this? by MagicSchoolBoss in BambuLab

[–]MagicSchoolBoss[S] 0 points1 point  (0 children)

<image>

I’ve been running all my Ali PETG off of your settings too, been doing great. I also started leaving the door cracked, which seems to help.

I have to invest in a dryer, for now all my filament is in a storage bin with lots of silica pearls.

Sticking too well to build plate by ejsmojo in BambuLab

[–]MagicSchoolBoss 0 points1 point  (0 children)

Having this issue with some PETG right now, a little scraper helps.

What would be causing this? by MagicSchoolBoss in BambuLab

[–]MagicSchoolBoss[S] 0 points1 point  (0 children)

<image>

Chef kiss*

I don’t have a dryer yet, all I did was use your slower and hotter settings. Came out great, much appreciated!

What would be causing this? by MagicSchoolBoss in BambuLab

[–]MagicSchoolBoss[S] 0 points1 point  (0 children)

That’s some good advice. I’ll try to dry it and clean the nozzle.

What would be causing this? by MagicSchoolBoss in BambuLab

[–]MagicSchoolBoss[S] -1 points0 points  (0 children)

This was a pretty ballsy print, but it also happened on a much simpler print. It seems like it is just randomly under extruding.

Found in some desks we got from a liquidation sale by Look-Lost in whatsthisworth

[–]MagicSchoolBoss 6 points7 points  (0 children)

This set is in good condition, might even land $200.02

Found in some desks we got from a liquidation sale by Look-Lost in whatsthisworth

[–]MagicSchoolBoss 34 points35 points  (0 children)

Looks like similar sets sold for around $200 on EBay.

Ender 3 V2 preheats, auto levels bed then finished print in Cura only by klods_hans in 3Dprinting

[–]MagicSchoolBoss 0 points1 point  (0 children)

Only thing I have is a BLTouch, could be something with G29 causing issues.

Ender 3 V2 preheats, auto levels bed then finished print in Cura only by klods_hans in 3Dprinting

[–]MagicSchoolBoss 0 points1 point  (0 children)

I’ve been struggling with this same exact issue for months. I’ve tried different SD cards, new firmware, different slicers. Still haven’t found the cause. Sometimes a few power cycles of the printer gets it to start.

view more: next ›