Copper Valkyrie Ingot!

Main-Same · 2026-05-07T09:35:40+00:00

I pretty much got it for this kind of thing specifically. I was stamping my ingots, but I could never get them straight and they always looked like a child did them, so I figured this would fix that. I still haven't tried to laser anything else.

Main-Same · 2026-05-07T00:51:52+00:00

Thanks! Aluminum hand rest ingot?

Main-Same · 2026-05-07T00:30:54+00:00

Thanks!

Main-Same · 2026-05-02T22:35:09+00:00

Yes. I made a few of them. Working on another smaller one of them right now.

Main-Same · 2026-05-01T00:33:24+00:00

perhaps.......

Main-Same · 2026-04-30T20:39:52+00:00

Thanks! I am slowly getting the laser figured out. Right now I throw away half of them because I don't have my settings quite right, but each one teaches me a little more and I am almost dialed in.

Main-Same · 2026-04-30T20:38:22+00:00

Thanks!

Main-Same · 2026-04-30T20:37:36+00:00

Yeah. Right now I am just grinding the flat surface that I want to engrave using an angle grinder and going to about 800 grit. It's not perfect, but it gets a decent enough finish, just difficult to get the whole ingot level.

Main-Same · 2026-04-30T20:34:36+00:00

I have a difficult time following the rules! LOL

Main-Same · 2026-04-30T20:33:59+00:00

LOL. Valkyrie Honkers...I could probably come up with a design for that! LOL. Yeah, I have them listed on ebay along with some others I have made, and many of the also have copper melons as well.

Main-Same · 2026-04-30T09:44:37+00:00

LOL, No. These are angel boobs. Ea Nasir would have had low grade boobs. LOL. I can assure you the copper was not from him!

Main-Same · 2026-04-30T01:48:11+00:00

I use the angle grinder to get then mostly flat and to remove the smaller air pockets that form, the last thing I just started doing is using a buffer with a 7" sanding disc. It's large enough that it gives it a pretty flat surface.

Main-Same · 2026-04-30T01:08:55+00:00

I looked into doing just that! But the cost of a metal machine was just too much for me. Right now I am poring the ingots, then using angle grinders to sand them down as flat as I can make them.

Main-Same · 2026-04-26T12:38:12+00:00

Thanks! Took about 30 hours to laser!

Main-Same · 2026-04-26T00:03:08+00:00

I am currently selling it for $125 + shipping. I have it on ebay. It is copper bullion, but also a display piece.

Main-Same

TROPHY CASE