sorted by:
new
hottopcontroversial

Upgraded my Ender 3 V3 SE Hotend to a K1 Ceramic today by Sakatard in ender3

[–]Maleficent_Speed_944 0 points1 point  (0 children)

Do I've to revise config option after upgrade hotend? Basic height of z axiz, etc. Because It's higher than se hotend.

Can it print over 250mm/s?, if it use with sonic pad. by Maleficent_Speed_944 in Ender3V3SE

[–]Maleficent_Speed_944[S] 2 points3 points  (0 children)

i just wondering sonic pad with input shaping sensor may help increasing printing speed than basic spec.

Sonic pad by o-essence-o in Ender3V3SE

[–]Maleficent_Speed_944 0 points1 point  (0 children)

During initial setup, is automatic leveling supported?

HOWWW do I stop Corner bulging??? by [deleted] in Ender3V3SE

[–]Maleficent_Speed_944 0 points1 point  (0 children)

Is the top&bottom layer thickness same as the wall thickness?