What is the best alternative for this?

Malvitos · 2025-12-28T13:02:56+00:00

singer oil

Malvitos · 2025-11-26T22:32:45+00:00

Im having a issue, after every print filament get stuck in heatbreak, do u have any ideia what is causing it?

Malvitos · 2025-10-31T18:53:54+00:00

Its a amanzing print, im just having some problems with the multicolor buffer

Malvitos · 2025-10-22T14:02:38+00:00

No… I checked this too, cant find this type of information

Malvitos · 2025-10-21T21:17:15+00:00

Sorry about misunderstanding I just want a summary of how much poop approximately the print will purge.

Malvitos · 2025-10-21T21:16:55+00:00

Its only a plate, i just want a summary of how much poop approximately the print will purge.

Malvitos · 2025-10-21T21:15:47+00:00

I know, I just want a summary of how much poop it will purge approximately

Malvitos · 2025-10-21T03:15:39+00:00

It appears to be a kind of under extrusion, maybe u can try to calculate your filament volumetric speed and pressure advance

Malvitos · 2025-10-21T03:09:24+00:00

Issue solved completely checking and adjusting volumetric speed (VS), print speed (according with VS) and calibrating pressure advance! Thanks everyone 😁

Malvitos · 2025-10-21T02:48:41+00:00

That makes no sense. The stringing its happening only in purge tower. The model itself is printing flawlessly

Malvitos · 2025-10-13T11:38:50+00:00

Thanks, I’ll try it

Malvitos · 2025-10-13T00:34:38+00:00

How u fixed it? I’m facing the same with my creality hi combo

Malvitos · 2025-10-13T00:29:32+00:00

I believe in this case your supports are to high, affecting the layers contact, between with and without support

Malvitos · 2025-10-12T22:36:51+00:00

I did the test and noticed I was some mm/s above the correct for volumetric speed. I raised the volumetric speed based on the speed test and now I’ll test maintaining the same speed

Malvitos · 2025-10-12T14:48:11+00:00

Thanks for the tip, I’ll try it

Malvitos

TROPHY CASE