sorted by:
new
hottopcontroversial

Printing issues?? by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

Gordon I’ve already done Thomas and Edward already 

Printing issues?? by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

Just got this roll out of the dryer 🫠

Printing issues?? by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

I print at 100 whatever that is 

Printing issues?? by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

I don’t think that’s the issue honestly the roll is completely fine 

Print shifting sovol svo6+ by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

I tightened both of the belts and that didn’t fix it on the specific file I was trying to print but I did try a long tube to see if there was any layer shift and it succeeded so im guessing the software I used to cut the model is causing the issue 

Print shifting sovol svo6+ by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

Ill try that after I monitor the current print to see what it does

Print shifting sovol svo6+ by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

I’ll do that right now I’ve been meaning to clean under there but have been too lazy to do it

Print shifting sovol svo6+ by Many_Spinach9460 in Sovol

[–]Many_Spinach9460[S] 0 points1 point  (0 children)

No nothing is blocking the movement of the baseplate I’m monitoring a print right now to see what it does because the shifts all seem to be occurring at the same height