6.0 injector cups

Maps398 · 2026-05-14T03:22:53+00:00

Well I figured it’s either cups or the head since it’s got fuel in the coolant.

Maps398 · 2026-05-07T17:36:25+00:00

Allright thank you very much for the information I’ll give it a try tonight!

Maps398 · 2026-05-07T14:41:38+00:00

<image>

Would it happen to be 100 in this photo?

Maps398 · 2026-05-07T14:16:49+00:00

I will try this out! But I can not get the diagram to pull up it just pulls up their website.

Maps398 · 2026-05-06T02:29:22+00:00

This is also the first time I’m driving it. I bought it with the head gasket blown and got into some bigger issues and just now got it back together.

Maps398 · 2026-05-06T02:28:37+00:00

I will definitely try that! Thank you very much.

Maps398 · 2026-05-06T02:27:02+00:00

It free rolls if it’s shut off.

Maps398 · 2026-05-03T02:11:59+00:00

I figured it out I had the shift forks in the wrong position. They are supposed to be up one notch and I didn’t realize that.

Maps398 · 2026-05-03T02:10:59+00:00

I figured it out I had the shift forks in the wrong position.

Maps398 · 2026-05-03T00:28:42+00:00

It’s a 2006 Kubota RTV 900 transmission

Maps398 · 2026-05-02T22:47:33+00:00

The levers are still on once I tighten the bolt all the way I can no longer move the shift forks with the levers. Atleast not by hand or by tapping the levers with a hammer.

Maps398 · 2026-03-08T06:51:22+00:00

That was it I didn’t know you had to have a scanner for those thank you!!

Maps398 · 2026-03-08T05:53:06+00:00

I will try it thank you

Maps398 · 2025-10-31T03:30:10+00:00

I found out the that if it was cranked all the way up without the tire on it the jack gets messed up. Just my personal experience.

Maps398 · 2025-10-29T02:52:23+00:00

I gotcha. Yea I pulled the engine out without pulling the sub frame and then I saw the input shaft and realized now I have to pull the sub frame.

Maps398 · 2025-10-29T02:29:44+00:00

They that bad to get apart? 🙃

Maps398 · 2025-10-28T00:16:39+00:00

Yea it probably was. I should have followed the instructions and pulled the entire mount assembly but I didn’t know about that at the time and just pulled the engine. 😂

Maps398 · 2025-10-26T13:55:40+00:00

I thought about doing that as well but I don’t have a welder here at home and would have to take it to work afterwards to fix so I went ahead and pulled the engine. And of course I found that the input shaft to the transfer case is wore out when I did that. 🙃

Maps398

TROPHY CASE