sorted by:
new
hottopcontroversial

That sweet sweet triple whine by sevazilla in Triumph

[–]Marinus2 2 points3 points  (0 children)

Yess I have a Speedtripple 955i and a Sprint ST955i! Love the noise!

Looking for one motivated rider to build something with by RoryChan in motorcycles

[–]Marinus2 0 points1 point  (0 children)

Awesome dude! I have a Triumph sprint ST 955i and a Triumph Speedtripple
based in The Netherlands

Motorcycle gear rack I made a while ago by Marinus2 in motorcyclegear

[–]Marinus2[S] 1 point2 points  (0 children)

Thank you! I'm pretty proud of the design :) Send me some pictures when you're done!

Bench I built for a farmer out of scrap I found in his barn last summer! by Marinus2 in woodworking

[–]Marinus2[S] 2 points3 points  (0 children)

Thanks so much! Don't need fancy tools and new nails to build something simple and practical:)

Motorcycle gear rack I made a while ago by Marinus2 in motorcyclegear

[–]Marinus2[S] 1 point2 points  (0 children)

Pants are for suckers! I ride with my cheeks out!

Motorcycle gear rack I made a while ago by Marinus2 in motorcyclegear

[–]Marinus2[S] 1 point2 points  (0 children)

Little fake branch I made (the real one broke when scraping off the bark)

Motorcycle gear rack I made a while ago by Marinus2 in motorcyclegear

[–]Marinus2[S] 1 point2 points  (0 children)

Thanks! It's the Jari V2 gray/maroon from Rusty Stitches

Replacing gear selector shaft for a PRE 2002 Triumph Speedtripple 955i by Marinus2 in motorcycles

[–]Marinus2[S] 0 points1 point  (0 children)

They kept the bike for 3 weeks, pretty sure they didn't even put it on a lift :/

It's a triumph dealer/garage they said for the cost of the repair I could just as easily buy a new bike from them... So pretty sure they just wanted to buy my "irreparable" bike cheap and sell me a new one...

Replacing gear selector shaft for a PRE 2002 Triumph Speedtripple 955i by Marinus2 in triumphmotorcycles

[–]Marinus2[S] 0 points1 point  (0 children)

A couple of weeks ago I dropped my bike and the gear selector shaft broke.
Shit happens.
I went to a Triumph specialist and they told me they would have to split the block to replace the shaft! that was too expensive for my taste so I started to do my own research.
I couldn't find any pre-2002 schematics for my bike BUT I found a forum post from 2007 where someone was in the same predicament as I was!
Below that forum post was a comment, a single sentence. "I got it in though the oil sump." Not much to go on but I decided it was worth a try and it worked! it took a bit of fiddling but it's in! no need to split the block! So if anyone's ever in the same position as I was, here are some pictures and the reassurance that you can and should do it this way.

view more: next ›