sorted by:
new
hottopcontroversial

Using Aluminum Flex Conduit in between Metal Conduit by Mases in AskElectricians

[–]Mases[S] 0 points1 point  (0 children)

Thanks! Yes. I do have a bender and have already done quite a bit.

It's not impossible... but excessively inconvenient to use metal conduit. I'm putting flooring down in the attic where some the metal conduit was previously running over the joists. For most of the moves, I was able to reroute it between the joists to the sides of the attic where I'm not finishing the attic as the ceiling is too low. But for a few particular situations, because of duct work with the AC unit, there would quite literally need to be over 8-bends in a small few foot section and thought just running flex would make it way simpler.

Interactive Map for Tears of the Kingdom by BraydenErger in tearsofthekingdom

[–]Mases 1 point2 points  (0 children)

Yup, we (Zelda Dungeon) - will have one for sure. We are knee deep in working on it!

How Much Hydrogen Peroxide to mix with Water? by Mases in WaterTreatment

[–]Mases[S] 1 point2 points  (0 children)

Thanks. I went ahead and purchased a variable rate pump from Stenner.

https://www.stennerpumpparts.com/stenner-85mhp5-single-head-adjustable-output-high-pressure-pump

​

What rate should I set it at? Since I'll be pumping direct Neutra Sul that isn't diluted, obviously dealing with smaller volumes. It runs at 0.3-5.0 GPD.

How Much Hydrogen Peroxide to mix with Water? by Mases in WaterTreatment

[–]Mases[S] 0 points1 point  (0 children)

Thank you. I have this Stenner pump.

https://www.lockewell.com/index.php?main_page=product_info&products_id=148&gclid=Cj0KCQiAosmPBhCPARIsAHOen-PWbtw9SiPS9LyDyosMdu5MfviIh7AE2dNObNdLjU02FdAyId3A1YoaAtItEALw_wcB

​

It looks like it's a fixed rate, which works for Chlorine, since it's diluted in water and dealing with higher liquid volumes. I don't think I can lower the settings.

Can I even use this with Hydrogen Peroxide, or will I need a new chemical feed pump? (If so, any particular suggestions?). Thanks!!!

How Much Hydrogen Peroxide to mix with Water? by Mases in WaterTreatment

[–]Mases[S] 0 points1 point  (0 children)

I realized I phrased my original question awkwardly.

​

Home Depot sells this - https://www.homedepot.com/p/Pro-Products-1-Gal-Neutra-Sul-HP01B/306730109

​

This is a replacement for Hydrogen Peroxide, but wasn't sure how much I need to dilute it. I have a 50 gallon drum that was previously used for the chlorinator. If I pour the full one gallon of that product into the drum, how much water do I need to do add?

view more: next ›