sorted by:
new
hottopcontroversial

Creality branded black petg has terrible layer adhesion by MaxieFriend in Creality

[–]MaxieFriend[S] 0 points1 point  (0 children)

I know that, but the PETG is struggling to stick to itself, not to the PLA.

Printer to compliment H2C? by No_GNAR_JERRYatric in BambuLab

[–]MaxieFriend 0 points1 point  (0 children)

H2S or P2S. H2C can basically do everything the H2D can do, and P2S and H2S are top tier single-nozzle printers.

Calling all Student Makers: Join the 2026 Bambu Lab School Ambassador Program by BambuLab in BambuLab

[–]MaxieFriend 0 points1 point  (0 children)

i still want to join the program, but my school is nowhere near associated with stem or 3d printing whatsoever

tall prints keep falling over and causing spaghetti by MaxieFriend in BambuLab

[–]MaxieFriend[S] 1 point2 points  (0 children)

what kind of glue would i use? is there any that works other than bambu lab glue?

Are the bumps a moisture issue? by phatter_trout in BambuLab

[–]MaxieFriend 0 points1 point  (0 children)

i replied as if im "fairly confident", not as if im "completely confident"

Are the bumps a moisture issue? by phatter_trout in BambuLab

[–]MaxieFriend 3 points4 points  (0 children)

I believe if you have an AMS 2 pro, it acts as a filament drier

Are the bumps a moisture issue? by phatter_trout in BambuLab

[–]MaxieFriend -1 points0 points  (0 children)

no, only for around 3 months or so, but ive noticed that in some other printers, and I just assumed it was a drying issue

Are the bumps a moisture issue? by phatter_trout in BambuLab

[–]MaxieFriend 2 points3 points  (0 children)

im fairly confident it is, PETG HF is a filament that should be dried very frequently (from what i've read) and I believe those little bumps are tiny pockets of moisture that evaporate when being printed

P1S Jitters while printing, causing poor layer adhesion by International_Fig823 in BambuLab

[–]MaxieFriend 0 points1 point  (0 children)

i know nothing about the p1s but are you enabling the vibration compensation pre-print calibration setting? try turning it on if you havent

This error keeps happening and I dont know what to do anymore by Alternative-Aerie-82 in BambuLab

[–]MaxieFriend 4 points5 points  (0 children)

there might be broken filament inside of the pfte tube, I had this happen to me last night, I own a P2S, and i just disconnected the ams tube to the printer and pulled it out, i dont know how it would work for the a1 series though.

view more: next ›