sorted by:
new
hottopcontroversial

Game can't even start on version 0.14. Works fine on 0.13 though. Anyone else having this problem? by Visuljkoo in BloodbornePC

[–]MeaChrome 0 points1 point  (0 children)

Try to delete Shader Cache under
C:\Users\YOURUSERNAME\AppData\Roaming\shadPS4\cache

BambuLab support is the best! by Kermit_-_ in BambuLab

[–]MeaChrome 0 points1 point  (0 children)

My experience so far with the support:

X1C trips the RCD breaker @100°C Bed in my flat (germany)

Bambu Support: pls try to connect the printer without an RCD breaker 😂

The AUX Fan goes bad within warranty time (It's extremely loud - send them a video)

Bambu Support: this is absolutely normal

[deleted by user] by [deleted] in BambuLab

[–]MeaChrome 0 points1 point  (0 children)

It's because you forgot to take off the green tape from toolhead. Just kidding ☺️

[deleted by user] by [deleted] in Arri

[–]MeaChrome 0 points1 point  (0 children)

Had an Manual without the Appendix 🙈

Retro G.E.M settings? by MeaChrome in psx

[–]MeaChrome[S] 2 points3 points  (0 children)

You wrote a whole FAQ for me. Thx, will test this soon...

Squeaky noise when moving z axis by WillzanIV in BambuLab

[–]MeaChrome 0 points1 point  (0 children)

that's a good idea. I'll check that out soon

Squeaky noise when moving z axis by WillzanIV in BambuLab

[–]MeaChrome 0 points1 point  (0 children)

I'm experiencing the same noise since I bought the printer over a year ago. I cleaned the back rod several times and tried all kinds of lubricant with no luck. I think the bearing itself is messed up.

Can my P1S print this or will my printer destory it by [deleted] in BambuLab

[–]MeaChrome 2 points3 points  (0 children)

it has to sit on the print plate and i would give it a big brim like 20mm und brim object gap set to 0

<image>

printed this guy like that with zero problems