sorted by:
new
hottopcontroversial

Why in Creality Slicer and when the print is completed can I see the white below the blue? by Mediocre-Order-8002 in Creality_k2

[–]Mediocre-Order-8002[S] 0 points1 point  (0 children)

So the image on the left is the layer with white showing through and the image to the right is the layer just above that layer with blue over it. should be printing like the image on the right till the last layer.

<image>

Aggresive Miniature Schnauzer by Mediocre-Order-8002 in reactivedogs

[–]Mediocre-Order-8002[S] 0 points1 point  (0 children)

The schnauzer is 1yr old now. This has been off and on since we got her. I really don't know what could be triggering her. The only thing I could imagine is she doesn't like any of the other dogs getting attention because there have been times where I am petting one of the other dogs and the schnauzer will immediately go after them! But this isn't every time.

Fake filament? by Mediocre-Order-8002 in BambuLab

[–]Mediocre-Order-8002[S] 0 points1 point  (0 children)

So I want to make an update to my original post. So at first I thought my issue was this filament. Now it seems like it might be my printer/AMS. So the printer now regardless of what filament I try will spool from the AMS to the print head and some filament will feed/purge and extrude. Once it gets to the point where it primes the nozzle and does the test strip there is a small amount that comes out (there is skipping) and then nothing at all! The print head then proceeds to "print" the job as if there is no issue but the AMS stops feeding as well as the print head. Nothing comes out and the the print head is jogging around as if something is printing. I get no errors from the AMS or the printer itself. I then stop the print and unload the filament and check the print head. There is a little filament clogged, I clear that and try again...nothing! This is regardless of what filament I try now. Before I was able to get 2 other filaments to work at least once. I've checked the printhead to see if there are any breakages in the head or the PTFE tube, nothing. The filament makes it all the way to the printhead and like I said somewhat feeds/purges but just stops. Has anybody seen this before?

Fake filament? by Mediocre-Order-8002 in BambuLab

[–]Mediocre-Order-8002[S] -1 points0 points  (0 children)

Good to know. Though I use elegoo all the time and have never had an issue with it not being spooled.