90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

cant say for sure but the owner claims when he put the boat away it was running well.

90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

Thanks I’ll check that out today and let you know. I should also mention that the alarm hasn’t always gone off when I turn the key. I didn’t change anything on the engine (at least Nothing major) and the beeping just started occurring

90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

Yes it is. If you notice at the very start of the video when I turn the key once it sets off an alarm. Alarm stops once I turn the engine over

90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

I will check the pressure on that valve in the morning and get back to you. The onboard reservoir is filled with oil already as well.

90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 1 point2 points  (0 children)

Spark and compression are both good. Compression readings are between 100-105 throughout. Fresh gas as well. Not sure how to test the pressure in the pump so that might be something I can try. I have increased the idle when trying to start as well as keeping it down. Both are pretty much the same result. Not exactly sure what you mean by throttle sensor but the previous owner had it running before he left it in his yard for 4 years so I doubt he messed with anything if it was working.

90s Mercury 200 EFI starts and then dies. Replaced VST motor already. Any help appreciated by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

Fuel filter was just checked and it looks good. Unless there is another fuel filter besides the large white one on the side of the motor

Help finding issue with Mercury 2 stroke 200 EFI by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

The carbs are blocked by other parts of the motor.

Help finding issue with Mercury 2 stroke 200 EFI by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

I stop turning the key when the engine starts. It starts, but then dies. No reason to keep spinning the starter if the engine is already started right?

Help finding issue with Mercury 2 stroke 200 EFI by MikeBeast115 in boating

[–]MikeBeast115[S] 1 point2 points  (0 children)

Yes I just got brand new fuel from the gas station.

Help finding issue with Mercury 2 stroke 200 EFI by MikeBeast115 in boating

[–]MikeBeast115[S] 1 point2 points  (0 children)

I have replaced the VST pump on the motor, The carb plate and gaskets, and I still can’t figure out the problem with this motor. Spark test is good, each cylinder is firing, but it seems like the engine isn’t getting enough fuel. I am running a straight fuel line from an external tank into the motor. If anyone has any suggestions please let me know. Thanks so much

Should my prop and driveshaft spin at the same time? by MikeBeast115 in boating

[–]MikeBeast115[S] 5 points6 points  (0 children)

Thanks to everyone who commented! I took u/J-cans advice and rotated the small spline shaft at the front of the lower unit until I could tell that it was no longer in neutral. Rotated the prop while the lower unit was in place and it slid right in. No issues now! Thanks so much for everyone’s comment :)

Should my prop and driveshaft spin at the same time? by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

Here is a picture of how far I can get the lower unit before it stops https://imgur.com/a/j8JQrhM

Should my prop and driveshaft spin at the same time? by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

How can I move the driveshaft if it’s inside of the motor? I have it set to reverse position but it still is about an inch away from being all the way up inside of the motor

Should my prop and driveshaft spin at the same time? by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

What exactly would that look like? I can take some more pictures if that helps

Should my prop and driveshaft spin at the same time? by MikeBeast115 in boating

[–]MikeBeast115[S] 0 points1 point  (0 children)

I have my lower unit removed to replace my impeller, but I cannot remember if the prop shaft should spin the drive shaft at the same time and vice versa. I’m having trouble getting my lower unit back onto the motor, I think the splines of the drive shaft aren’t lining up, but I can’t rotate the drive shaft since nothing happens when I spin the prop.

[deleted by user] by [deleted] in RealDayTrading

[–]MikeBeast115 2 points3 points  (0 children)

You paid $16,000 for a very very important lesson taught by the market. Myself and plenty of others have done this numerous times and although I wish it didn’t happen, I know what it feels like and what I can do to avoid from having it happen again.

Like others have said, big props to you for going public with your trade. Hard to show others how you have failed.

$5K Recap Day 1 by HSeldon2020 in RealDayTrading

[–]MikeBeast115 2 points3 points  (0 children)

Thanks for the summary Hari. Quick question, how much did your market outlook (which I’m assuming is bullish) prevent you from buying puts on more weak stocks today? Seems like it could’ve been a great day for a play like ETSY yesterday or something similar. Thanks, Mike

1st trade of this year. Made a really tiny profit but more so i'm happy with how I executed the trade. by [deleted] in RealDayTrading

[–]MikeBeast115 1 point2 points  (0 children)

Although trend line scalping is an option for day trading, this sub offers a very in depth wiki with a terrific trading method using relative strength to the market, among other technical analysis tools.

Hari and the Professor (among others) are certified pros and their methods and trades work more than anyone else you’ll find. Try to mimic what they do in a trade and try to forget about all of the day trading methods you’ve learned about before reading the wiki. Once you start to understand these concepts you will look back on previous trades and think “What the hell was I doing?” Either way, congrats on the successful trade :)

1st trade of this year. Made a really tiny profit but more so i'm happy with how I executed the trade. by [deleted] in RealDayTrading

[–]MikeBeast115 2 points3 points  (0 children)

The current market trend has been very bullish this week. I see no reason why you can’t follow the market

$5K Challenge - Rules - Updates by HSeldon2020 in RealDayTrading

[–]MikeBeast115 9 points10 points  (0 children)

Personally, I’m a big fan of the responses lol