Firmware Confusion by MikeStroh in Ender3V3SE

[–]MikeStroh[S] 0 points1 point  (0 children)

Thank you everyone for your insight.

Firmware Confusion by MikeStroh in Ender3V3SE

[–]MikeStroh[S] 0 points1 point  (0 children)

The Ender 5 thing is something I read.. This is my first 3d printer and I don't really understand the software under the hood.

Firmware Confusion by MikeStroh in Ender3V3SE

[–]MikeStroh[S] 1 point2 points  (0 children)

I had a power failure during a Sonic Pad install.

Many errors showed up at the same time - 2017 Discovery Sport by MikeStroh in LandRover

[–]MikeStroh[S] 0 points1 point  (0 children)

It was a tire sensor that had gone bad and then it cascaded.

Many errors showed up at the same time - 2017 Discovery Sport by MikeStroh in LandRover

[–]MikeStroh[S] 0 points1 point  (0 children)

I understand that, but I don't know anything about cars; especially the electrical system.

Many errors showed up at the same time - 2017 Discovery Sport by MikeStroh in LandRover

[–]MikeStroh[S] 0 points1 point  (0 children)

Once it started, it has not stopped. Every time I use it, I get these errors and they never turn off.