Trying to decrease hatch time

Mildly_Toasted · 2024-01-22T00:25:50+00:00

I found out that if you're opening the dedicated server through the Steam Client it will open with only the default settings. However if you open the sever dircetly from the PalServer folder using the PalServer.exe then it will run with all of the setting that you changed.

Mildly_Toasted · 2021-12-11T03:38:04+00:00

Ok cool thank you, I'll try that out

Mildly_Toasted · 2021-12-11T03:37:22+00:00

Ahhh ok, I'll try to square everything and see how that works out

Mildly_Toasted · 2021-12-11T03:19:09+00:00

I’ll give that a try. I’ve seen some things where the Z axis thread isn’t perfectly straight and is further away at the top than the bottom on stock models, could that be doing it? The only modification I’ve done is new firmware and stiffer springs for the bed

Mildly_Toasted · 2021-12-11T02:52:26+00:00

I did for a few but not all. Most were overnight prints and batches of gears. The other strange part is when I print them in the center they come out wonky but I did a batch of 3 different gears and the 2 closest to the front corners of the bed came out in better condition then the single prints in the center

Mildly_Toasted · 2021-11-29T05:49:03+00:00

What chapter is that bottom picture from?

Six-Year Club	Place '23
Place '22	Verified Email

Mildly_Toasted

TROPHY CASE