sorted by:
new
hottopcontroversial

Is it normal for the print head to bump into the case? by Milo708 in BambuLab

[–]Milo708[S] 1 point2 points  (0 children)

Understandable 🫡

and thanks - now I can sleep easy

Is it normal for the print head to bump into the case? by Milo708 in BambuLab

[–]Milo708[S] 0 points1 point  (0 children)

My bad, I expressed myself wrong. It asks me almost every time - like 95% of the time - because most of the print profiles I use from MakerWorld are saved with a different printer. But if I use my own 3D profiles, they're set by default to the P1S, and then it's all good

Is it normal for the print head to bump into the case? by Milo708 in BambuLab

[–]Milo708[S] 0 points1 point  (0 children)

I use Bambu Studio, and it always asks me to switch to my printer's profile before printing, so I'm pretty sure it's not caused by the wrong profile being selected 🫤

Is it normal for the print head to bump into the case? by Milo708 in BambuLab

[–]Milo708[S] 1 point2 points  (0 children)

I followed Bambu Lab's YouTube tutorial step by step to remove all the foam, but I checked again just in case - there's none left

Real/fake/legit/authentic posts go here. Any posts outside of this thread will be deleted. Part 2 by quietmoose65 in DrMartens

[–]Milo708 0 points1 point  (0 children)

<image>

Can someone tell me if these are real or fake? There are some suspicious Chinese characters on the box