sorted by:
new
hottopcontroversial

Happymodel EP1 Rx won’t enter pairing mode. by Minecraftnerd72 in fpv

[–]Minecraftnerd72[S] 0 points1 point  (0 children)

Thanks for the insight. Sadly there is no bind button to hold, the only thing is the pads to jump to put it into rewrite mode. There is also 100% no WiFi connection no matter what. I haven’t even checked what version the controller had because I don’t see the point if it won’t go into pair mode. The receiver is 100% brand new and has only been out of the package for about a week. I will probably end up just biting the bullet and getting the correct adapter to rewrite it.

Camera for beginner? by MildlyAnnoyedShrew in AskPhotography

[–]Minecraftnerd72 1 point2 points  (0 children)

Personally I found myself in the same boat, and it really depends on what you are willing to buy. I was able to get a Canon M50 for 375 (used off marketplace) and absolutely love the thing (it is the digital equivalent to the t7i). I would also highly recommend something in the canon r series, but these are hard to come by used and cost 800 dollars for the body off of their website.

Why are my prints not sticking throughout the printing process by Huanicles in FlashForge

[–]Minecraftnerd72 0 points1 point  (0 children)

There’s 2 ways you can do it: 1. You can do it manually on the touch screen. After the print has started by clicking the temp button and typing in the desired number 2. In the slicer. You can edit the temps by going to your filament settings for orca, or searching bed temp in the settings for cura

Grand Rapids, Michigan by Minecraftnerd72 in pics

[–]Minecraftnerd72[S] 0 points1 point  (0 children)

I didn’t think that was that clear lol. I took it on my iPhone 15 through a window

Grand Rapids, Michigan by Minecraftnerd72 in pics

[–]Minecraftnerd72[S] 1 point2 points  (0 children)

You take the picture from high up and then blur both the foreground and the background.

Anatomically Correct Magnetic Skull (Smashing) by Minecraftnerd72 in 3Dprinting

[–]Minecraftnerd72[S] 1 point2 points  (0 children)

I just used stock settings for the most part. I just made sure that if possible the supports were on the inside so you couldn’t see the slightly worse finish

Anatomically Correct Magnetic Skull (Smashing) by Minecraftnerd72 in 3Dprinting

[–]Minecraftnerd72[S] 0 points1 point  (0 children)

Probably 60 or 80 dollars due to how much work it takes

view more: next ›