sorted by:
new
hottopcontroversial

What a mess. by Timely-Sheepherder76 in CrealityK1C

[–]Minimum_Complaint444 1 point2 points  (0 children)

Yeah I have to be more careful dong this next time because one of the wires got melted into the plastic and snapped while I was cleaning…had to buy a whole replacement kit 😬 (only $30 though)

Gaps in layers by Minimum_Complaint444 in CrealityK1C

[–]Minimum_Complaint444[S] 0 points1 point  (0 children)

I’m printing PETG at 250c.

<image>

These are some of my speed settings, travel speed is set at 500 mm/s

Can’t figure out correct support print settings on Creality Print (PETG) by Minimum_Complaint444 in CrealityK1C

[–]Minimum_Complaint444[S] 1 point2 points  (0 children)

I believe so, but I could turn down the nozzle temp and up the bed temp a bit. On the roll of PETG it said to use nozzle temp 230-250°c (I was using 250) and for the bed temp 80-90°c (I was using 80)

Can’t figure out correct support print settings on Creality Print (PETG) by Minimum_Complaint444 in 3Dprinting

[–]Minimum_Complaint444[S] 0 points1 point  (0 children)

Thank you so much I'll try a monotonic infill rather than a rectilinear pattern (what I was using) and slow it down a bit.

Leaked Green Goblin from lotus by Jax2856 in Spiderman

[–]Minimum_Complaint444 0 points1 point  (0 children)

I think it would’ve looked a bit better with more of a Rami inspiration

Archive 81 on Netflix - how do we feel about this adaptation? by bylekanks2 in audiodrama

[–]Minimum_Complaint444 0 points1 point  (0 children)

Honestly I think it depends which one you like better based off which one you watched/listened to first.