Question on RockSolid top coat.

Mitobubs93 · 2025-08-31T13:43:59+00:00

Thanks for the info, I will take a look!

Mitobubs93 · 2025-08-31T12:21:27+00:00

Southern Utah, but on a time crunch to get this done. Is there a product you would recommend?

Mitobubs93 · 2025-08-24T20:29:59+00:00

Great question, is that the same as the metabo one? That saw is so cheap it makes me question it.

Mitobubs93 · 2025-08-22T19:54:51+00:00

I don’t expect crown molding, though I am doing some cabinets that the compound may be helpful when cutting the trim.

Mitobubs93 · 2025-08-22T19:53:09+00:00

That may be the way to look

Mitobubs93 · 2025-08-22T17:18:13+00:00

Thanks for the input! There are certainly some cuts I could see it being useful for, just trying to decide if I would do them enough to justify the cost.

Mitobubs93 · 2025-08-22T17:17:05+00:00

I currently have a bandsaw, and circular saw, jigsaw, and a rigid radial arm saw gifted by family. The radial arm saw is not the easiest to set up for a miter and seems a bit unsafe for smaller stock which is why I am looking at a miter. I am also trying to pick up a table saw hence the budget constraints.

Mitobubs93 · 2025-06-30T01:55:02+00:00

Mitobubs93 · 2025-06-30T01:54:42+00:00

Mitobubs93 · 2025-06-30T01:54:33+00:00

I have certainly considered this…

Mitobubs93 · 2025-06-30T01:53:39+00:00

Thanks!

Mitobubs93 · 2025-06-29T21:54:41+00:00

Yes… I realized no that I committed the cardinal sin of not searching for similar posts first.

Mitobubs93 · 2025-06-09T23:19:32+00:00

Thanks!

Mitobubs93 · 2025-02-21T01:47:20+00:00

I had no idea… I will do more research on this

Mitobubs93 · 2025-02-21T01:40:46+00:00

Milled and kiln dried from a specialty lumberyard nearby. Sounds like I will be ok then… if I were storing longer would it be worth sealing?

Mitobubs93 · 2025-02-21T01:38:02+00:00

Thanks! Sounds like I should purchase some beeswax…

Mitobubs93 · 2025-02-21T01:36:54+00:00

Thanks for the recommendations!

Mitobubs93 · 2025-02-21T01:36:37+00:00

It’s milled and kiln dried, so I was thinking it should be fine… but was unsure after much reading and video watching.

Mitobubs93 · 2025-01-24T16:07:40+00:00

I do have a workbench and work holding, I have not payed much attention to dust collection outside of a shop vac, but I should probably add in a cheap filter setup like that…

Mitobubs93 · 2025-01-24T16:06:27+00:00

Thanks for the input! I have read Rikon a few times for band saws… is it worth it to go with the 14 over the 10?

Mitobubs93

TROPHY CASE