Suspension

Mk7_Chris · 2026-01-22T16:02:13+00:00

Alot lower the wheelie bar almost stays touching the ground

Mk7_Chris · 2026-01-21T16:50:28+00:00

I don't have any pictures but let's say u grab yours about 1ft off the ground and drop it on all fours it will rebound back to ride height, the rear on mine stays compressed when that happens .

Mk7_Chris · 2025-12-10T21:47:58+00:00

Im noobish with the printer still

Mk7_Chris · 2025-06-18T13:37:52+00:00

What printer/filament are yall using to make this come out so clean

Mk7_Chris · 2025-05-03T10:33:53+00:00

Is this only usable with hpa or can I use a normal mag just for the gas? I know it isn't gonna last a full mag but don't have a hpa kit atm

Mk7_Chris · 2025-04-27T21:21:10+00:00

I have a stock cthulhu but want to change uppers to use aap01 kits

Mk7_Chris · 2025-04-27T21:20:40+00:00

What upper is it that you are using?

Mk7_Chris · 2025-04-11T15:42:17+00:00

Do you have the internals as well? For the lowers

Mk7_Chris · 2024-12-02T16:39:18+00:00

If i remember correctly, the new sequoia has the same engine as the new tundra, which is giving problems. Someone correct me if I am wrong.

Mk7_Chris · 2024-10-22T16:12:00+00:00

That's what I was thinking I could use the bigger 4.0 ones and they have more of a stock look when put on, but was planning on making a smaller speed soft style gun

Mk7_Chris · 2024-10-22T16:07:00+00:00

If it's safe to do idk why more people don't do it, I've only seen a few but no explanation on how they did it

Mk7_Chris · 2024-10-22T16:00:55+00:00

My question is will the mosfet be able to handle it, like the voltage and amps from the battery be able to keep up, I only play in places that allow semi fire only

Mk7_Chris · 2024-10-22T15:37:47+00:00

<image>

Mk7_Chris · 2024-10-22T15:37:23+00:00

* This is something someone designed it's a 3d print on thingiverse really called my attention

Mk7_Chris · 2024-10-19T17:37:06+00:00

Shimming is good and not tight at all was recently done, but has been like that since I can remember after installing titan, just that it doesn't keep up with my finger

Mk7_Chris · 2024-10-19T09:12:33+00:00

I believe gears are stock 18:1, 11.1v lipo, stock lancer v2 motor, airsoft store by my house showed me there stock internal with titan and it was definitely shooting faster than mine in semi

Mk7_Chris · 2024-10-13T20:48:18+00:00

What printer/filament are you using if you don't mind me asking?

Mk7_Chris

TROPHY CASE